Advertisement
Tightening torque 3.0 N·m (0.30 kgf·m, 2.2 lb·ft)
a
c
Tightening torque 6 N·m (0.6 kgf·m, 4.4 lb·ft)
a
d
c
d
Tightening torque 6 N·m (0.6 kgf·m, 4.4 lb·ft)
INSTALLING THE INCLUDED PARTS
b
c
b
– 6 –
WARNING
8 Position the lever when it cannot touch
obstacles while the bicycle is moving. If not,
the lever could be unlocked unexpectedly,
causing the front wheel to come off, result-
ing in an accident with severe injury or
death.
8 Fasten the lever d at position where the tip
does not touch other parts when the lever
d is lowered.
8 Fasten the lever d facing backward from
the direction of travel in such a way that it
cannot easily touch obstacles that might be
encountered while riding.
TIP
If the lever d of the front axle 2 is too hard and
cannot be lowered, or if it is too loose and cannot
be lowered for it to be locked, turn the nut f again
to loosen or tighten it, adjusting so that it can be
fastened securely.
3. Installing the handlebar stem
Position the handlebar stem a in a straight line
with the front wheel.
Tighten the bolts b and c, in that order, to the
specified torques.
4. Installing the handlebar
Install the handlebar a so that the knurled part
b is at the center of the handlebar holder c,
then tighten the 4 handlebar holder c bolts d
to the specified torque.
NOTICE
The handlebar a should not touch the frame
when it is turned fully to the left or right.
Advertisement
