Advertisement
1
b
Tightening torque 4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
1
Tightening torque 40 N·m (4.0 kgf·m, 30 lb·ft)
INSTALLING THE INCLUDED PARTS
a
a
1
– 10 –
9. Tightening the seat pin
Insert the saddle and seat post 1, then tighten
the bolt a to the specified torque.
1
Saddle and seat post
WARNING
8 Insert the seat post far enough that the raise
limit b is not visible. If installed at a posi-
tion at which the raise limit b is visible, the
seat post, clamp, or even frame may break,
which could cause the rider to lose control
and fall.
8 Always tighten fasteners to the correct
torque. Bolts that are too tight can stretch
and deform. Bolts that are too loose can
move and fatigue. Either mistake can lead
to a sudden failure of the bolt, causing the
rider to lose control and fall.
NOTICE
Do not insert the seat post completely when
lowering the saddle. The bottom edge of the
seat post could touch parts inside the seat
pipe, breaking the seat post or the parts inside
the seat pipe. If the seat post is inserted fully,
lift it slightly then fasten it.
10. Installing the pedals
Install the pedal 1 to the crank a, then tighten
to the specified torque.
1
Pedals (left and right)
TIP
8 Right screw for the right pedal
8 Left screw for the left pedal
11. Installing the battery pack
Check that the battery pack 1 is fully charged
according to owner's manual procedures, then
install the battery pack 1.
1
Battery pack
1
A
1
B
each
1
C
Advertisement
