Axis And Spindle Test Run - Siemens SINUMERIK 840DiE sl Manual

Axis and Spindle Test Run

13.1 Prerequisites
13.1.1 Drives: SINAMICS S120
References
13.1.2 Drives: SIMODRIVE
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Enabling signals must be set to allow an axis to be traversed directly from the
control:
S
Drive: Parameters and terminals
S
NCK: Interface signals
Infeed
Parameter/Terminal
p0840
p0844
p0845
p0852
X21.3 (+24 V) and X21.4 (ground)
Drive
Parameter/Terminal
p0840
p0844
p0845
p0848
p0849
p0852
X21.3 (+24 V) and X21.4 (ground)
p0864
p1140
p1141
p1142
SINAMICS S120 Commissioning Manual
/GH2/ Booksize Power Modules Manual
Applies to the following SIMODRIVE drives:
S
SIMODRIVE 611 universal/universal E
S
SIMODRIVE POSMO SI, CD/CA
13
Significance
ON/OFF1
1st OFF2
2nd OFF2
Enable operation
EP terminals enable (pulse enable)
Significance
ON/OFF1
1st OFF2
2nd OFF2
1st OFF3
2nd OFF3
Enable operation
EP terminals enable (pulse enable)
Infeed enable
Ramp–function generator enable
Ramp–function generator Start
Setpoint enable
13-421