Hitachi SH7760 Solution Engine2 Overview page 128

Start of erite processing
Connect the host system with
an accessory RS-232C cable.
Mount the EPROM of
Vxx on the debug board.
Short-circuit the jumper pin
(J1) on the debug board.
Connect an AC adapter to CN4.
Start terminal software on the host
system.
Turn on the power with
the power switch (SW1).
Start message displayed on
the host system screen?
Y
Write to the flash ROM with the
monitor command "FL."
N
Program (written to the
flash ROM) to be run?
Y
Turn OFF the power with the
power switch (SW1).
Disconnect the AC
adapter from CN14.
Open the jumper pin (J1) on
the debug board.
Connect the AC adapter to CN14.
Turn OFF the power with
the power switch (SW1).
End of write processing
Figure 10.2 Procedure to write to Flash ROM
N
Turn OFF the power switch
(SW1).
Disconnect the AC adapterfrom
CN12.
Check for cables and settings.
Connect the AC adapter
from CN14.
125