Hitachi SH7760 Solution Engine2 Overview page 121

(3) Monitor program start
Connect Solution Engine2 and the host system with an RS-232C cross cable. When the monitor program starts,
In the above starting message, a version number is displayed in xx.
h'00000000
~
h'003FFFFF
h'00400000
~
h'007FFFFF
h'00800000
~
h'00BFFFFF
h'00C00000
~
h'00FFFFFF
h'01000000
~
h'01FFFFFF
h'02000000
~
h'03FFFFFF
h'04000000
~ Board control register area
h'07FFFFFF
h'08000000
~
h'0BFFFFFF
h'0C000000
~
h'0FFEFFFF
h'0FFF0000
Area used by the monitor
~
h'0FFFFFFF
h'10000000
~
h'13FFFFFF
h'14000000
~
h'17FFFFFF
h'18000000
~
h'1BFFFFFF
Figure 10.1 Memory Map (Real Memory Space)
the following starting message appears on the host system screen.
================================================
SH7760 Self Debugger
-----------------------------------------------------------------------------
(C) Copyright 2002-2005. Hitachi.Ltd. All rights reserved.
=================================================
Ready >
CS0 area
EPROM area monitor
(bus width: 16bit)
program
Debug LED area
Switch area
Unused area
Flash memory area
Unused area
CS1 area
(bus width: 16bit)
CS2 area
Extension area (CS2) (bus width: arbitrary)
CS3 area
User area SDRAM area
(bus width: 32bit)
program
CS4 area
Extension area (CS4)
(bus width: arbitrary)
CS5 area
Extension area (CS5)
(bus width: arbitrary)
CS6 area
PCMCIA area
(bus width: 16bit)
Ver x.xL (****/**/**)
H [elp] for help messages...
118