Samsung SVD-4120A Quick Install Manual

SVD-4120/4020 Series
Quick Install Guide
The lightning flash with arrowhead symbol, within an equilateral
triangle is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operating and maintenance
(servicing) instructions in the literature accompanying the appliance.
INFORMATION -This equipment has been tested and found to comply with limits for
a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will required to correct the interference
at his own expense.
WARNING - Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
CAUTION : To prevent electric shock and risk of fire hazards:
Do NOT use other than specified power source.
Do NOT expose this appliance to rain or moisture.
This installation should be made by a qualified service person and should conform to
all local codes.
1
1. INSTALLATION
Notes
• The installation should be done by qualified service personnel or sysytem installers.
• If the ceiling material is not strong enough to hold the installation screws, the camera may
fall off. Reinforce the ceiling as needed.
1) Remove the dome cover and shield case from the main body by loosening
the three dome cover screws.
Mounting Bracket
Main Body (Camera)
Shield Case
Dome Cover
2) And then remove the main body from mounting
bracket by the four main body screws.
Notes
• Loosen the three dome cover mounting screws by using the supplied wrench.
2
Installing the camera on a ceilling
Affix the mounting template(supplied) to the
mounting surface.
Secure the camera mounting bracket to the
position where the camera should be mounted
with the supplied four screws.
Ø5 tapping screw x 4 (supplied)
Pass the power and BNC cable through the hole you
want to pass them when mounting the main body on
the mounting bracket.
Secure the camera on its mounting bracket with
the four screws.
M4 machine screw x 4
3