Siemens SINUMERIK 840D sl Programming Manual page 407

Table 3-1
Number
42000
42010
42400
42800
43210
43220
43230
43300
43420
43430
43510
43520
43700
43710
43720
43730
43740
43750
43760
43770
43780
43790
1) This G command addresses the setting data.
Supplementary conditions
Initialization value: Global user variables (GUD)
● Only INIPO (Power On) can be defined as the initialization time for global user variables
(GUD) with the NC range of validity.
● In addition to INIPO (Power On), INIRE (reset) or INICF (NEWCONF) can be defined as
the initialization time for global user variables (GUD) with the CHAN range of validity.
● In the case of global user variables (GUD) with the CHAN range of validity and INIRE (reset)
or INICF (NEWCONF) initialization time, for an NC reset, mode group reset and "Activate
machine data", the variables are only reinitialized in the channels in which the named events
were triggered.
Initialization value: FRAME data type
It is not permitted to specify an initialization value for variables of the FRAME data type.
Variables of the FRAME data type are initialized implicitly and always with the default frame.
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Programmable setting data
Identifier
$SC_THREAD_START_ANGLE
$SC_THREAD_RAMP_DISP
$SA_PUNCH_DWELLTIME
$SA_SPIND_ASSIGN_TAB
$SA_SPIND_MIN_VELO_G25
$SA_SPIND_MAX_VELO_G26
$SA_SPIND_MAX_VELO_LIMS
$SA_ASSIGN_FEED_PER_REV_SOURCE
$SA_WORKAREA_LIMIT_PLUS
$SA_WORKAREA_LIMIT_MINUS
$SA_FIXED_STOP_TORQUE
$SA_FIXED_STOP_WINDOW
$SA_OSCILL_REVERSE_POS1
$SA_OSCILL_REVERSE_POS2
$SA_OSCILL_DWELL_TIME1
$SA_OSCILL_DWELL_TIME2
$SA_OSCILL_VELO
$SA_OSCILL_NUM_SPARK_CYCLES
$SA_OSCILL_END_POS
$SA_OSCILL_CTRL_MASK
$SA_OSCILL_IS_ACTIVE
$SA_OSCILL_START_POS
Work preparation
3.1 Flexible NC programming
G command
1)
SF
DITS/DITE
PDELAYON
SETMS
G25
G26
LIMS
FPRAON
G26
G25
FXST
FXSW
OSP1
OSP2
OST1
OST2
FA
OSNSC
OSE
OSCTRL
OS
OSB
407