Installation - Fujitsu RAID 0/1 SAS based on LSI MegaRAID User Manual

Modular RAID 6Gb/s (SAS2.0)
4.4.4

Installation

This section describes how to install the SAS RAID controller in a server.
V
CAUTION!
To safeguard against data loss, remember to back up your data before
you change your system configuration.
To install the new controller, proceed as follows:
Step 1 Unpack the controller
Unpack the new controller in a static-free environment. Remove
it from the anti-static bag and inspect it for damage.
If the controller appears to be damaged, contact the Fujitsu
support service.
Step 2 Prepare the server
Turn off the server and remove the cover from the chassis.
Step 3 Install the new SAS RAID controller
Insert the controller in a suitable PCIe slot on the system board.
Press down gently but firmly to ensure the controller is properly
seated in the slot. Secure the controller to the server chassis with
the PCI card hold down latches. Connect the SAS and/or SATA
HDDs located in the system to the SAS cable connector(s) on
the controller. Refer to your server specific Upgrade and
Maintenance Manual for information on the PCIe slot and
installing the controller.
58
Modular RAID Controllers