5.5.3
Connectors and jumpers
The following figure shows the location of the connectors and jumpers on the
SAS RAID controller.
Figure 38: "PRAID EP420e" board layout
1
HDD LED1 connector
2
HDD LED2 connector
3
CacheVault Flash Module (ONFI) interface
4
Cache write pending connector
5
Two SAS connectors
Connectors
Connector
HDD LED1
Global hard disk
drive (HDD) activity
HDD LED2
Global drive fault
LED
Modular RAID Controllers
Type
2-pin connector
2-pin connector
Modular RAID 12Gb/s (SAS3.0)
Description
Connects to an LED that indicates
activity on the drives connected to
the controller.
Connects to an LED that indicates
activity on the drives connected to
the controller.
103