Optional Accessories; Protecting The Environment - DeWalt DWE7491 Original Instructions Manual

ENGLISH
WARNING: To reduce the risk of
injury, regularly clean the table top.
WARNING: To reduce the risk of
injury, regularly clean the dust collection
system.
The blade guard assembly (k) and throat plate must
be placed in position before operating the saw.
Before use,carefully inspect upper and lower blade
guards as well as the dust extraction tube to
determine that it will operate properly. Ensure that
chips, dust or work piece particles cannot lead to
blockage of one of the functions.
In case workpiece fragments are jammed between
saw blade and guards, disconnect the machine from
the power supply and follow the instructions given
in section Mounting the saw blade. Remove the
jammed parts and reassemble the saw blade.
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Regularly clean the dust collection system:
1. Unplug the saw.
2. Turn the saw on its side, so the bottom, open
part of the unit is accessible.
3. Open the dust access door (qq) shown in
figure 19 loosening the two screws and then by
pressing the side clips (rr). Clean out the excess
dust, and re-secure by pushing the side clips
completely into place then tightening the lock
screws.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Replace blade guard when worn. Contact your local
D WALT service centre for details on a blade guard
E
replacment.
SAW BLADES: ALWAYS USE 250 mm noise
reduced saw blades with 30 mm arbour holes.
Blade speed rating must be al least 5000 RPM.
Never use a smaller diameter blade. It will not be
guarded properly.
48
APPLICATION
Construction Saw Blades (fast rip)
General Purpose
Fine Crosscuts
Woodworking Saw Blades
(provide smooth, clean cuts)
Fine crosscuts
Consult your dealer for further information on the
appropriate accessories.

Protecting the environment

Should you find one day that your D
needs replacement, or if it is of no further use to you,
do not dispose of it with household waste. Make this
product available for separate collection.
environmental pollution and reduces the demand for
raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D
reached the end of their working life. To take
advantage of this service please return your product
WALT, have
E
to any authorised repair agent who will collect them
on our behalf.
You can check the location of your nearest
authorised repair agent by contacting your local
D WALT office at the address indicated in this
E
manual. Alternatively, a list of authorised D
repair agents and full details of our after-sales
service and contacts are available on the Internet at:
www.2helpU.com
BLADE DESCRIPTIONS
DIAMETER
250 mm
250 mm
250 mm
Separate collection. This product must not
be disposed of with normal household
waste.
WALT product
E
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
WALT products once they have
E
TEETH
24
40
60
WALT
E