Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for WhisperKool SC PRO Series
Summary of Contents for WhisperKool SC PRO Series
- Page 1 SC PRO SERIES OWNER’S MANUAL SC PRO 2000 SC PRO 3000 SC PRO 4000...
- Page 2 WhisperKOOL. Every effort has been made to ensure that the information in this manual is accurate. WhisperKOOL is not responsible for printing or clerical errors.
-
Page 3: Table Of Contents
TABLE OF CONTENTS Introduction ............. 2 Before You Start . -
Page 4: Introduction
INTRODUCTION Customer Service Thank you for purchasing a WhisperKOOL cooling system. We strive to provide the highest-quality products and the best possible customer service. If you have any questions about your system, please call us at 1-800-343-9463 or visit www.whisperkool.com. -
Page 5: Before You Start
4. For your convenience, the WhisperKOOL unit has two power inlets: one on the side of the unit, and the other on the back. Use the selector switch, located on the right side of the unit, to select the inlet you would like to use. -
Page 6: Receiving And Inspecting The Unit
NOTE: WhisperKOOL units are manufactured in the USA and tested prior to shipment. Please leave the WhisperKOOL unit in its original box until you are ready for installation. If the unit is to be stored for any length of time prior to installation, ensure that the unit is stored on a flat level surface in the upright position. This will allow you to move the product safely without damaging it. -
Page 7: Quick Reference Guide
SC PRO Series QUICK REFERENCE GUIDE Front / Side View Controller Probe input Control panel (see page 10 for details) Bottle probe Rear / Side View Rear power inlet Drain port www.whisperkool.com | Page 5... -
Page 8: Controller Layout
CONTROLLER LAYOUT Refer to page 18 for complete listing of buttons and symbols. Menu Navigation Power On/Off and Value Increase (hold for approx. 3 seconds) (Press and hold to manually enter Anti-Frost mode.) and Escape SET (ENTER) Menu Navigation and Value Decrease (Press and hold to enter the parameter menu.) -
Page 9: Preparing The Wine Cellar
Insulation Insulation is REQUIRED in order to properly use WhisperKOOL products. It is vital that all walls and ceilings be insulated to keep the cellar temperature as consistent as possible during the summer and winter months. Standard fiberglass or rigid foam insulation is normally used in cellar construction;... -
Page 10: Mounting The Unit
NOTE: Do not attempt to mount the unit in a wall recess or attempt to camouflage or cover the unit with any sort of aftermarket grille, accessory, etc. This can restrict airflow, prevent the unit from working properly, and void the warranty. Please feel free to call WhisperKOOL Customer Service with any questions or concerns regarding installation requirements. Door and Door Seal An exterior-grade (1¾”) door must be installed as a cellar door. - Page 11 In some cases, it may be advisable to install a vent fan to dissipate heat from within the exhaust area. However, you must have a fresh air inlet as well. If your unit requires ducting, please contact WhisperKOOL to obtain a specially designed ducting plenum for the unit.
-
Page 12: Pre-Installation
PREPARING THE UNIT FOR INSTALLATION The WhisperKOOL Unit requires a dedicated 115-volt, 15-amp circuit. The unit draws a large number of amps during its initial startup. By designating a dedicated circuit breaker, you will guarantee the unit has enough power to run effectively. -
Page 13: Installation Guide
Using two 2x4s at 14.5 inches in length and eight 6d nails, secure the upper and lower supports to the right and left studs, just inside the sheetrock. Make sure that the internal height remains at 16 inches (2000/3000/4000) so that the WhisperKOOL unit will fit snugly through the framed cut-out. -
Page 14: Preparing The Unit For Installation
PREPARING THE UNIT FOR INSTALLATION Single-Piece Mounting Bracket The SC Series utilizes a single-piece mounting bracket. This sturdy bracket frames the installation location and secures the unit to the wall. Applying Insulation Tape Locate the six-foot piece of black foam tape included with the unit. Align one end of the foam tape with the upper left corner of the rear side of the mounting bracket. -
Page 15: Installing The Unit Through The Wall
The screws should penetrate the studs as well as the upper and lower supports to provide adequate support for the WhisperKOOL unit (see illustration). Seal all cracks and gaps around the WhisperKOOL unit with an air- tight sealant or caulking to prevent air leakage. -
Page 16: Condensation Drain Line
DRAIN LINE Condensation Drain Line Tube All units come equipped with a drain line for additional removal of excess condensate. This is a backup system to the condensate evaporator. It is mandatory to install the drain line attachment. The condensate evaporator will heat and dissipate the excess moisture through the rear of the unit. -
Page 17: Liquid Measuring Thermostat System
SC PRO Series LIQUID-MEASURING THERMOSTAT SYSTEM (BOTTLE PROBE) WhisperKOOL cooling units come with a liquid-temperature-measuring thermostat. The self-calibrating bottle probe contains a sensor chip, which communicates back and forth with the thermostat. This results in a consistent tempera- ture setting and accuracy. Wine should be kept at a very precise, controlled temperature and humidity. By measuring the liquid temperature rather than air, the unit will operate 75–80% of the time. -
Page 18: System Operation
40°F, the display will blink three times and Setpoint continue normal operation. The setpoint is preset at the factory (WhisperKOOL) to 55°F. It Bottle Probe Failure Protection can be adjusted by the customer between 50°F and 70°F (in In the event that a bottle probe should fail, the APST (Advance 1°F increments). -
Page 19: Controller
SC PRO Series CONTROLLER FUNCTIONS Button/Symbol Normal Functions ON/OFF • Press and hold the ON/OFF button for approximately 3 seconds to turn the unit on or off. Note: This does not disconnect power from the unit. In order for the power to be shut off from the unit, the power cord must be unplugged from the power outlet. -
Page 20: Alarm Codes
Enhancement back into the cellar. (The WhisperKOOL unit, however, cannot increase the humidity of the cellar.) This parameter should not be adjusted below 1. Adjustments should be made in increments of 5, with a maximum of 15 and a minimum of 1. -
Page 21: Wiring Schematic
SC PRO Series WIRING SCHEMATIC www.whisperkool.com | Page 19... - Page 22 WIRING SCHEMATIC 111519 Page 20 | 1-800-343-9463 SC PRO...
- Page 23 SC PRO Series NOTES www.whisperkool.com | Page 21...
-
Page 24: Troubleshooting Guide
TROUBLESHOOTING GUIDE Unit has ice forming on the evaporator Possible cause Solution Evaporator coil is dirty Clean coil with a vacuum. If coil is very dirty, use a spray bottle with a small amount of liquid dish detergent. Spray coil, let set for 5 minutes, then flush with fresh water. - Page 25 SC PRO Series Unit leaks water Possible cause Solution Unit is not level Unit should be level in wall to prevent leaking Drain line clogged or kinked Check drain line to make sure water can flow freely Drain is clogged, preventing water from escaping Disconnect exterior drain line and clear it out.
-
Page 26: Maintenance Schedule
MAINTENANCE SCHEDULE Monthly 1. Check coils 2. Check for unusual noise or vibration 3. Check drain line to see if it is above the waterline (if draining into a vessel) Every Six Disconnect exterior drain line and check for blockages. Weeks Quarterly Use a vacuum with brush attachment to clean coils;... -
Page 27: Technical Assistance & Accessories
SC PRO Series TECHNICAL ASSISTANCE WhisperKOOL Customer Service is available Monday through Friday from 6:00 a.m. to 4:00 p.m. Pacific Standard Time. The appointed customer service representative will be able to assist you with your questions and warranty information more effectively if you provide them with the following: •... -
Page 28: Installation Terms & Conditions
A. Two (2) Year Limited Warranty: For the period of TWO (2) YEARS (the “Limited Warranty Period”) from the date of original sale of a Product by WhisperKOOL, if a WhisperKOOL Product is found to be defective in material or workmanship after undergoing WhisperKOOL’s Customer Service troubleshooting, then, subject to the WhisperKOOL Product Limited... - Page 29 16. No one has any authority to add to or vary the limited warranty on this Product. 3. Product Installation Requirements: A. Prior to installing a WhisperKOOL Product, the End User must read the WhisperKOOL Owner’s Manual and thereafter the End User must follow the required installation, use and maintenance procedures set forth by WhisperKOOL in WhisperKOOL’s Owner’s Manual.
- Page 30 Product Limited Warranty And Product Installation Requirements), and further these Terms and Conditions of Sale shall be interpreted as though drafted jointly by WhisperKOOL and Purchaser. Any dispute will be resolved by the courts in and for the County of San Joaquin, State of California, and all parties, WhisperKOOL, Purchaser and End User, hereby irrevocably submit to the personal jurisdiction of such courts for that purpose.
- Page 31 E-mail: support@whisperkool.com Web: www.whisperkool.com B. Technical Assistance: WhisperKOOL Customer Service is available Monday through Friday from 6:00 a.m. to 4:00 p.m. (PST). The Customer Service representative will be able to assist you with your questions and warranty information more effectively if you provide them with the following: 1.
- Page 32 WhisperKOOL 1738 E. Alpine Ave Stockton, CA 95205 1-800-343-9463 www.whisperkool.com...
Need help?
Do you have a question about the SC PRO Series and is the answer not in the manual?
Questions and answers