NEC Express5800 Series Installation Manual page 63

Chapter 1 Installing Operating System
8. Update /boot image file.
# mv /boot/initramfs-'uname -r'.img /boot/initramfs-'uname -r'.img.bak
# dracut /boot/initramfs-'uname -r'.img 'uname -r'
9. Run the following command to reboot the system. After reboot, perform Step 6 to check if RAID1
device md4 is displayed.
# reboot
This completes creation of volume.
The system may fail start normally if /etc/mdadm.conf and boot image file are not
Important
created correctly in Steps 7 and 8.
If the system fails to start, you can restore the backup file you have created in earlier
steps to start the system. However, the created volume will be erased.
Restart the system before using the created volume to check if it is correctly
created.
Express5800/R320c-E4, R320c-M4 Installation Guide (Linux)
2. Setting up Red Hat Enterprise Linux 6 Server
63