Installing Ft Server Control Software - NEC Express5800 Series Installation Manual

Chapter 1 Installing Operating System

2.2.6 Installing ft Server Control Software

Follow the steps below to install ft Server Control Software.
1. Login the system with root user. If you login with graphical mode, select [Others...] to login.
2. Set the ft Server Control Software Install CD to optical disk drive. After a while, the drive will be
automatically mounted.
3. Enter the following command to confirm whether all the RAID devices are synchronized. (If they are
in the middle of resync process, wait until the process completes before you move on to the next
step.)
# cat /proc/mdstat
4. Run the following command to install ft Server Control Software.
# /media/FT905380/ftsys/RHEL6.5/install.sh
5. The following message appears when installation completes.
Enter YES to reboot now or NO to allow a manual reboot later: [YES]
6. Press the <Enter> key to reboot the system.
In this section, description is based on the assumption that the optical disk drive has been
Tips
mounted automatically. If the optical disk drive is not mounted automatically depending on
your environment, mount it on the desired location manually. If the mount destination
differs, substitute it for the actual destination appropriately.
Tips After ft Server Control Software has been installed, the system starts with text login mode
(run level 3).
The indication on screen may be corrupted when the system is shutdown or rebooted.
However, end processing is normally terminated.
Express5800/R320c-E4, R320c-M4 Installation Guide (Linux)
2. Setting up Red Hat Enterprise Linux 6 Server
43