Restart; Restore - Siemens SINUMERIK 840D sl Commissioning Manual

● An IP area with specification of the valid bits, e.g. "128.128.12.0/24"
If the specification of the source host is completely missing, this is normally acknowledged
with an error message. However, an exception is when the "sc openport" command is
entered in a shell opened via SSH. The permitted host is taken from the environment
variable $SSH_CLIENT that contains the IP of the SSH client.
If the opening was successful, an ID number is output in a status message:
sc: Port tcp/25 is open, rule ID is 6620
This ID can be used with "sc closeport" to manually close the port earlier.
See also
Parameter "FirewallOpenPorts" in the "basesys.ini" file.
3.4.11

Restart

Description
Syntax:
Alternative names:
Privilege level:
The action "sc restart" triggers a controlled shut down of the machine (stops all subsystems
and the basic system), and then initiates a restart. The effect is the same as the "reboot"
command in the basic system, which can only be executed by "root".
3.4.12

Restore

Description
Syntax:
Alternative names:
Privilege level:
A backup created using "sc save" can be restored to the controller using "sc restore".
Operating principle
As for "sc save", a restore is only possible from the service system or if subsystems are
stopped. If "sc restore" reports an error, for example that the restore will cause running
subsystems to crash, you can use the option "-force" to force the operation – just as for "sc
save".
NCU Operating System (IM7)
Commissioning Manual, 07/2007, 6FC5397-1DP10-2BA0
sc restart
reboot
service
sc restore [-full|-addon|-addon+|-oem|-oem+|-user]
[-force] [-nodelete] [-update] [-restart] FILENAME
---
user
Service Commands
3.4 Description of the actions
33