Keurig K-3500 Use & Care Manual
Hide thumbs
Also See for K-3500:
- Cleaning & start-up procedure (11 pages) ,
- Quick start manual (12 pages)
Advertisement
Advertisement
Table of Contents
Related Manuals for Keurig K-3500
Summary of Contents for Keurig K-3500
- Page 1 Use & Care Guide Get the most from your new Keurig brewer ®...
- Page 2 125 psig. touchscreen. WARNING: Keurig® requires the use of an external water filter such as the Omnipure KQ8A NOTE: An external filter (KQ8A, #5572) can be mounted on the rear surface of Water Filter, available from Keurig®. Failure to use a filter invalidates the brewer warranty.
- Page 3 Before You Brew (continued) You may wish to install a shut-off valve between the water source and the Omnipure KQ8A water filter. To do this, cut some LLDPE tubing to size and connect it by pushing the tubing into the shut-off valve until secure.
- Page 4 Brew Your First Cup Turn the brewer on. The power switch is located at Place a 12 oz. mug on the drip tray plate and then the bottom left hand side of the brewer on the back. fully raise the handle. Lower the handle to close the The brewer’s touchscreen will display “Please connect lid over the K-Cup®...
- Page 5 Brew Your First Cup Brewer Features (continued) Strong Brew increases the strength and bold taste of your coffee’s flavor. For bolder coffee, press the STRONG button and select your brew size. Place a mug on the drip tray. Lift the handle. A separate delivery path for hot water allows you to brew Place a K-Cup®...
-
Page 6: Menu Controls
If the brewer is alerting you to perform a “descale”, have You can select multiple images to use as a screensaver, as well your Keurig® Authorized Distributor descale the brewer as the duration for each image and the number of minutes Grounds in your coffee before the screensaver starts. -
Page 7: Caring For Your Brewer
Regular cleaning keeps your brewer running smoothly. Always be sure to turn off your brewer before cleaning. For detailed brewer cleaning instructions and videos, visit commercial.keurig.com. For service, please contact your Keurig® Authorized Distributor. Brewer Exterior Keep your brewer looking its best by cleaning the exterior from time to time. - Page 8 PHA, remove the half rim, then squeeze the two snap tips on the rear of its flip seat to release. The PHA can be cleaned by submerging it in Keurig® Descaling solution, or a vinegar solution (1:3), for 12 hours or more. There may be residual coffee grounds in the groove and the flip seat.
-
Page 9: Descaling Your Brewer
30 minutes before continuing with the rinse. clip the drain tubes back into place and replace the drain For further information on descaling, please contact your Keurig® Authorized Distributor. plugs. Power the brewer back on. Connect a Flojet pump system to the brewer to add Keurig®... - Page 10 Have Questions? taste in your beverage (such as chlorine or mineral tastes), we recommend using bottled or filtered water. Do not use We’re here to help. Visit commercial.keurig.com for step-by-step distilled water. videos on cleaning, descaling, and more. A Rinsing Brew refers to running a hot water cycle with no use of K-Cup®...
-
Page 11: Limited One-Year Warranty
Nor does this warranty cover damages caused by use normal use for one-year from the date of purchase. Keurig, a Keurig of non Keurig ®... - Page 12 If the brewer is not used daily, run a rinse brew before brewing with a K-Cup® pod. ** Descale can be conducted before and after an extended time of storage to maximize the cleaning effectiveness. For more instructions on cleaning or how to descale, please contact your Keurig® Authorized Distributor. DC0000002555 REV A...
Need help?
Do you have a question about the K-3500 and is the answer not in the manual?
Questions and answers
where is the Vent Value located and how do I order a new one?