Connect Pump Start Relay - Rain Bird ESP-Me Series User Manual

Connect Pump Start Relay

Connect an optional Pump Start Relay to the ESP-Me
controller.
NOTE: The ESP-Me controller DOES NOT provide
b
main power for a pump.
CAUTION: Do not route the pump start relay wires
d
through the same opening as the power wiring.
NOTE: The controller can support a maximum Coil
b
Inrush current of 11VA and a maximum Coil Hold
current of 5VA.
The following Rain Bird Pump Start Relays are available in
the USA only:
l RBSR24WG1 - Universal Pump Start Relay
l RBPL24WG1 - Pump Start Relay with Pressure Switch
For the most up to date compatibility list of pump
start relays, visit our website at: www.rainbird.com/
controllersupport
NOTE: This controller is not compatible with the
b
Hunter PSR22 and PSR52.
©
RELAY
INPUT
PUMP START
RELAY
ESP-Me User Manual
9
VT MV COM 5 6 7 11 12 13
1 2 3 4 8 9 10 14 15 16
VT MV COM
1 2 3 4
VT = VALVE TEST
CONNECT
120 VAC
COMMON
TO EXTERNAL
POWER SOURCE
NOTE: Default run times for program A is 10 minutes
b
for stations 1-4.
CAUTION: To avoid Dead Heading your pump do
d
one of the following for all unused stations (module
installed but not connected to a station wire):
l Connect jumper wire across unused stations.
l Set Station Run Time(s) to 0.
l Set the station to Bypass the MV.
To Bypass the Master Valve for any Station:
17 18 19
20 21 22
VT MV COM
1 2 3 4
VT MV COM
1 2 3 4
VT = VALVE TEST
CONNECT
120 VAC
JUMPER
WIRES ON
UNUSED
STATIONS
Turn the dial to Set Station
1.
Run Times.
Press and HOLD both
2.
and at the same time.
Press or
3.
desired Station; then press
to set MV ON or
or
MV OFF.
STATION
1 MVON
5 6 7 11 12 13 17 18 19
8 9 10 14 15 16 20 21 22
to select the
Installation