Install The Rear Hard Drive Cage; Install The Network Interface Card Into Expansion Card Riser 1 - Dell EMC Integrated Data Protection Appliance DP4400 Service Manual

Remove and replace assemblies

Install the rear hard drive cage

Install the network interface card into expansion card riser 1

Dell EMC Integrated Data Protection Appliance DP4400 2.4 Service Procedures Guide
56
5. Connect the NVMe card.
Procedure
1. Align the screws on the hard drive cage with the screw holes on the system.
2. Lower the hard drive cage into the system until it is firmly seated.
3. Using Phillips #2 screwdriver, tighten the screws to secure the hard drive cage
to the system.
4. Connect all the cables to the rear hard drive backplane.
Figure 47 Installing the 3.5 inch rear hard drive cage
Before you begin
Follow all safety guidelines.
Procedure
1. Unpack the network interface card and prepare it for installation.
Note
For instructions, see the documentation accompanying the card.
2. Pull the expansion card latch.
3. If installed, remove the filler bracket.