Starting The Engine - Toro Groundsmaster 360 31223 Operator's Manual

Figure 18
1. Pin
2. Hairpin
3. Raise the roll bar to the upright position
18).
4. Secure the roll bar with the 2 pins and 2 hairpins
(Figure 18).
Lowering the Roll Bar
Important:
Do not use the seat belt when the roll
bar is in the lowered position.
1. Remove the hairpins, push the roll bar forward
against the springs, and remove the 2 pins
(Figure 18).
2. Lower the roll bar to the down position
18).
3. Install the 2 pins into the pivot plates and secure
the pins with the 2 hairpins

Starting the Engine

1. If installed, raise the roll bar up and lock it into
place, sit on the seat, and fasten the seat belt.
2. Ensure that the traction pedal is in the N
position.
3. Engage the parking brake.
4. Move the power-takeoff (PTO) switch to the O
position (Figure 19).
g014172
3. Roll bar (raised position)
4. Roll bar (lowered position)
(Figure
(Figure
(Figure 18).
EUTRAL
1. Power-takeoff switch
(PTO)
2. Ignition switch
5. Move the throttle lever midway between the
F and S
AST
6. Turn the ignition key clockwise to the R
position (Figure
The glow-plug-indicator light should turn on for
6 seconds.
1. Start
2. Run/glow plug
7. After the glow-plug-indicator light turns off, turn
the key to the S
starts, release the key.
Important:
more than 15 seconds per minute to avoid
overheating the starter motor.
Note:
You may need to repeat this procedure
FF
when starting the engine for the first time after
adding fuel to an empty fuel system.
25
Figure 19
3. Glow-plug light
4. Throttle lever
positions (Figure 19).
LOW
20).
Figure 20
3. Off
4. Glow-plug-indicator light
position. When the engine
TART
Use starting cycles of no
g014175
UN
g014176