Odor Fade Warning; Operating Instructions - Craftsman CMXEHAO60FAV Instruction Manual

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!

ODOR FADE WARNING

WARNING:
Asphyxiation Hazard
•
Do not use this heater for heating human living quarters
• Do not use in unventilated areas.
• The flow of combustion and ventilation air must not be obstructed.
• Proper ventilation air must be provided to support the combustion
air requirements of the heater being used.
• Refer to the specification section of the heater's manual, heater data
plate, or contact the factory to determine combustion air ventilation
requirements of the heater.
• Lack of proper ventilation air will lead to improper combustion.
• Improper combustion can lead to carbon monoxide poisoning lead-
ing to serious injury or death.
• Symptom of carbon monoxide poisoning can include headaches,
dizziness and difficulty in breathing.
FUEL GAS ODOR:
LP gas and natural gas have man-made odorants added specifically for
detection of fuel gas leaks.
If a gas leak occurs you should be able to smell the fuel gas. Since
Propane (LP) is heavier than air you should smell for the gas odor
ANY GAS ODOR IS YOUR SIGNAL TO GO INTO
low to the floor.
IMMEDIATE ACTION!
• Do not take any action that could ignite the fuel gas. Do not operate
any electrical switches. Do not disconnect any power supply or
extension cords. Do not light matches or any other source of flame.
Do not use your telephone.
• Get everyone out of the building and away from the area
immediately.
• Close all propane (LP) gas tank or cylinder fuel supply valves, or the
main fuel supply valve located at the meter if you use natural gas.
• Propane (LP) gas is heavier than air and may settle in low areas. When
you have reason to suspect a propane leak, keep out of all low areas.
• Use your neighbor's phone and call your fuel gas supplier and your
fire department. Do not re-enter the building or area.
• Stay out of the building and away from the area until declared safe
by the firefighters and your fuel gas supplier.
• FINALLY, let the fuel gas service person and the firefighters check
for escaped gas. Have them air out the building and area before you
return. Properly trained service people must repair any leaks, check
for further leakages, and then relight the appliance for you.
ODOR FADING ‑ NO ODOR DETECTED
• Some people cannot smell well. Some people cannot smell the odor
of the man-made chemical added to propane (LP) or natural gas. You
must determine if you can smell the odorant in these fuel gases.
• Learn to recognize the odor of propane (LP) gas and natural gas.
Local propane (LP) gas dealers will be more than happy to give you
a scratch and sniff pamphlet. Use it to become familiar with the fuel
gas odor.
• Smoking can decrease your ability to smell. Being around an odor
for a period of time can affect your sensitivity to that particular odor.
Odors present in animal confinement buildings can mask fuel gas
odor.
• The odorant in propane (LP) gas and natural gas is colorless and the
intensity of its odor can fade under some circumstances.
• If there is an underground leak, the movement of gas through the
soil can filter the odorant.
• Propane (LP) gas odor may differ in intensity at different levels. Since
Propane (LP) gas is heavier than air, there may be more odor at lower
levels.
• Always be sensitive to the slightest gas odor. If you continue to
detect any gas odor, no matter how small, treat it as a serious leak.
Immediately go into action as discussed previously.
CRAFTSMAN, Inc. | Forced Air Propane Construction Heater
ATTENTION ‑ CRITICAL POINTS TO REMEMBER!
• Propane (LP) gas has a distinctive odor. Learn to recognize these
odors. (Reference Fuel Gas Odor and Odor Fading sections above.
• Even If you are not property trained in the service and repair of the
heater, ALWAYS be consciously aware of the odors of propane (LP)
gas and natural gas.
• If you have not been properly trained in repair and service of
propane (LP) gas then do not attempt to light heater, perform service
or repairs, or make any adjustments to the heater on the propane
(LP) gas fuel system.
• A periodic sniff test around the heater or at the heater's joints;
i.e. hose, connections, etc., is a good safety practice under any
conditions. If you smell even a small amount of gas, CONTACT YOUR
FUEL GAS SUPPLIER IMMEDIATELY. DO NOT WAIT!

OPERATING INSTRUCTIONS

(
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE)
PREPARING FOR OPERATION
1. Check the heater for possible shipping damage. If any is found,
immediately notify the factory. (1-888-331-4569)
2. Follow all of the "Precautions".
3. Connect the POL fitting of hose and regulator assembly to the
propane cylinder by rotating the POL nut counterclockwise into
the propane cylinder's valve outlet and securely tighten with a
wrench.
4. Connect the hose to the heater by rotating the hose fitting
clockwise.
5. Securely tighten all gas connections with a wrench.
6. Open the cylinder's gas valve and check all gas connections with a
soap and water solution. DO NOT USE A FLAME.
7. Connect power cord to well-grounded 115V, 60 Hz, 1Ø source of
power.
8. When using an extension cord, make certain that it is a 3-wire
(grounded) cord of proper wire size.
START
1. Turn gas valve knob to the OFF position.
2. Wait five minutes to clear any gas, then if you do not detect any
gas odor then proceed to the next step.
3. Turn gas supply ON by rotating the knob on the tank
counterclockwise.
4. Push in and turn gas control knob to the IGN position. The burner
will light.
5. Continue to hold the knob for 30 seconds or until the burner stays
lit.
6. If the burner does not stay lit repeat the lighting procedure.
7. Release knob and then rotate gas valve counterclockwise to
desired setting.
STOP
1. Securely close valve on the propane cylinder.
2. Continue to operate heater until all fuel in the hose has burned.
3. Unplug the power cord.
4
Operator's Manual