Configuring The Voip Pstn User; Configuring The Pstn User Data - Huawei SmartAX MA5616 Configuration Manual

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l Run the display if-h248 state command to check whether the MG interface is in the normal
l Run the quit command to quit the global config mode, and then run the display if-h248
----End
Example
To enable H.248-based MG interface 0, do as follows:
huawei(config)#interface h248 0
huawei(config-if-h248-0)#reset coldstart
Are you sure to reset MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#quit
huawei(config)#display if-h248 all
--------------------------------------------------------------------------------
MGID
--------------------------------------------------------------------------------
0
--------------------------------------------------------------------------------

7.1.2 Configuring the VoIP PSTN User

After an MG interface is configured, you can add public switched telephone network (PSTN)
users on the MG interface to implement the VoIP service.

7.1.2.1 Configuring the PSTN User Data

This topic describes how to configure the PSTN user data (the same as the corresponding data
on the MGC) on the MG interface so that the POTS terminal can access the network to implement
the VoIP service.
Prerequisites
The POTS service board must be inserted into the planned slot.
Context
Table 7-5
attributes of the PSTN user, you need to modify them according to the service requirements.
Table 7-5 Default settings of the attributes of the PSTN user
Parameter
Sequence of sending the phone
number of the calling party
Format of the phone number of the
calling party
Issue 04 (2011-10-30)
state.
all command to check whether the MG interface is in the normal state.
TransMode State
UDP Normal
NOTE
You can add a service board in two ways (see the Usage Guideline of the board add command). It is
recommended that you insert the service board into the planned slot and then confirm the board.
lists the default settings of the attributes of the PSTN user. When configuring the
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
MGPort MGIP
2944 10.10.10.11
Default Setting
Ringing and then sending the phone number
SDMF (FSK single data message format)
7 Configuring the Voice Service
MGCPort MGCIP/DomainName
2944 10.10.20.11
232