Table of Contents
Advertisement
I
Startup
9
Optional keypad FBG11B
0 0
9.4
Optional keypad FBG11B
9.4.1
Keypad functions
STOP
RESET
RUN
188
Key arrangement and symbols on keypad:
The UP/DOWN and ENTER/OUT buttons are used for navigating through the mmodule
is used for setpoint specification.
Use UP/DOWN to select symbols and change values.
ENTER/OUT to activate and deactivate the symbols or parameter menus
out
Enter
Press "RUN" to start the drive.
RUN
"STOP/RESET" is used for resetting errors and for stopping the drive.
STOP
RESET
The STOP/RESET button has priority over a terminal enable or an enable via the inter-
face. If you stop a drive using the STOP/RESET key, you have to enable it again by
pressing the RUN key.
NOTE
After switching off the power supply, press the STOP key to revoke the lock.
The STOP/RESET key can be used for performing a reset after a fault has occurred with
a programmed error response. The drive is then inhibited and must be enabled using
the RUN key. You can deactivate the STOP function with parameter 760 using FBG11B.
If you stop the drive with the STOP/RESET key, the display Stop is flashing. This signal
indicates you have to enable the drive using the "RUN" key.
After copying the parameter set in MOVITRAC
®
B, the unit is also stopped.
System Manual V2 – MOVITRAC® B
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MOVITRAC B Series and is the answer not in the manual?
Questions and answers
Amps setting
The SEW MOVITRAC B Series has the following amp settings:
- At 1 × AC 110V: 1.04A
- At 1 × AC 230V: 0.63A
These values are specified for the power supply input.
This answer is automatically generated
I need information regarding frequency and voltage setting
The SEW MOVITRAC B Series supports the following voltage and frequency settings:
Voltage settings:
- 3-phase AC: 400 V (up to 125% current)
- 3-phase AC: 400/500 V
- Single-phase AC: 230 V
Frequency settings:
- 4 kHz
- 8 kHz
- 12 kHz
- 16 kHz
These settings apply to both shielded and unshielded motor cables, with different maximum cable lengths depending on the frequency.
This answer is automatically generated