Installing The Discharge Chute - Toro 1800 Power Curve Operator's Manual

2. Carefully insert the right side of the upper tubing over
the end of the lower right side tubing (Fig. 2).
3. Carefully insert the left side of the upper tubing into
the end of the lower left side tubing (Fig. 2).
4. Squeeze the upper tubes together, and wiggle the upper
tubes down until the mounting holes in the upper and
lower tubing line up (Fig. 2).
Figure 2
1. Upper tubing
5. Place the mounting plate over the tubes (Fig. 3). Align
the mounting plate holes with the upper and lower
tubing holes.
2
4
Figure 3
1. Mounting plate
2. Shroud
6. Insert the end of the chute crank through the hole in
the shroud. Turn the chute crank rod lightly until the
flattened end drops into the slot in the gear. Firmly
push the chute crank into the gear until it snaps into
place (Figs. 3 and 4).
1
SQUEEZE
2
1531
2. Lower tubing
1
3
1532
3. Chute crank
4. Gear
2
1. Chute crank
7. Secure the upper and lower tubing and the mounting
plate together with two #10–24 machine screws and
locknuts.
Note: Position the screw heads on the outside of the
mounting plate. Be careful not to damage the internal
electrical wiring when inserting the screws. If the
wiring blocks the hole, use a blunt 1/8-in. punch to
carefully route the electrical wiring away from the aligned
holes.

Installing the Discharge Chute

1. Position the deflector onto the discharge chute and
align the mounting holes (Fig. 5).
1
4
3
1. Chute deflector
2. Chute
3. Rubber washer
6
1
Figure 4
2. Chute crank gear
5
6
2
1534
Figure 5
4. Carriage bolt
5. Metal washer
6. Locknut
1533