Advertisement
3. Align the hole in the beacon bracket with the hole in
the ROPS and install the new bolt with an existing
washer
(Figure
2).
Figure 2
1. Nut
2. Washer (existing)
4. Install the new nut and an existing washer, and tighten
them to a torque of 15 N∙m (11 ft-lb).
Note: Do not overtighten them, as this will make the
ROPS difficult to fold.
5. Install the beacon stand to the beacon bracket
3).
Note: Rotate the cable as you screw in the connector.
This prevents the cable from being twisted.
Figure 3
1. Stand
2. Seal
6. Loosen the wing nut and remove the beacon
3. Bolt
(Figure
3. Nut
(Figure
1. Wing nut
7. Plug the beacon onto the top of the beacon stand
(Figure
5).
8. Tighten the wing nut on the clamp
4).
1. Wing nut
2. Star washer
9. Route the cable down the front of the ROPS frame,
ensuring that it cannot be trapped or chafed.
10. Connect the cable to the mating connector on the main
wiring loom, situated near the horn, with the orange
and black wires.
2
Figure 4
Figure 5
(Figure
6).
Figure 6
3. Washer
4. Bolt
Advertisement
