Mitsubishi Electric JT-SB116JH2-S-NA Handbook page 22

(11) Heater (PTC)
1 Unscrew the side panel left (L) and right (R) clamping screws.
(Two PTT screws 4×16, indicated by )
2 Remove the side panel L in the direction of the arrow.
Assembly precautions
• Install the side panel L after installing the PCB cover for the power
circuit board.
• Take care not to pinch the lead wires.
• Fit the side panel L into the groove of the panel (back) and the base.
3 Remove the side panel R in the direction of the arrow.
Assembly precaution
Fit the side panel R into the groove of the panel (back) and the base.
─ 22 ─
Side panel L
Panel (back)
Panel (back) Base
Side panel L Groove
Side panel R
Base Panel (back)
Base Panel (back)
Side panel R Groove
Base