Verify That The Dm1000 Is Correctly Connected To Your Video Editor - Yamaha DM 1000 Startup Manual

5. Verify that the DM1000 is correctly connected to your video
editor
Now you must verify that the DM1000 is correctly connected so that it can be
controlled by the video editor. If you are unable to control the DM1000 V2 from
your video editor, it is important to determine whether the fault lies in the settings
of the editor or in the settings of the DM1000. Although it is a simplified method,
the following procedure will allow you to determine this by watching the
DM1000's error display.
5.1 On the keyboard of the video editor, press the key that selects the player or
recorder device (e.g., P1, P2, or REC key) or the ALL STOP key.
5.2 Check whether an indication of "REMOTE Parity Error" appears in the
bottom line of the DM1000's LCD screen. If this message does not appear,
change the setting in the screen as described in step 5.3, and try the operation
of step 5.1 again. If this message appears, it means that some type of
commands are being received from the editor. Perform step 5.4 to set the
parity correctly.
5.3 In the DISPLAY ACCESS section, repeatedly press the [SETUP] key to
access the REMOTE (REMOTE PORT SETUP) page of the SETUP screen.
Move the cursor to the ESAM PARITY parity field, select a setting other than
the current setting, and then perform step 5.1 again. Continue doing so until
the "REMOTE Parity Error" indication appears at the bottom of the LCD
screen in step 5.2. If this does not appear, it is probable that the DM1000 is
not correctly connected to the video editor, so you will need to check the
settings from step 1. In this state, the DM1000 cannot be controlled from the
video editor even if you proceed to the next step.
7