Pair The Input Channels - Yamaha DM 1000 Startup Manual

Control from a video editor

Hide thumbs Also See for DM 1000:

Table of Contents

14. Pair the input channels

If the signals being played back from the VTR are stereo, using the DM1000's Pair

function will allow you to handle them as a stereo signal, and control them by a

single fader and ON/OFF switch.

You can pair the channels either by using the [SEL] keys or by making the setting

in the LCD screen. For details, refer to the DM1000 owner's manual.

If the channels of a stereo input signal are panned to left and right, the monitor

signal will also be stereo. With the factory settings, panning two paired channels to

far left and far right will raise the level by approximately 3 dB in comparison to

when the channels are centered. However, you can make settings so that the level

does not change when paired channels are fully panned. This setting is made in the

PREFER1 page of the SETUP screen. To access this page, press the DISPLAY

ACCESS section [SETUP] key repeatedly to access PREFER1 (PREFERENCE1).

If Nominal Pan is checked, the level will not change when panned fully.

Table of Contents