Set Program Start Time(S) - Toro Plus Series Satellite User Manual

Set Program Start Time(s)

This procedure will determine when each program will start during a 24 hour period. Note the following
characteristics:
• Each program can have from 1 to 12 start times.
• Start times can be set to the minute.
• Program operation can be prevented for any of the 12 start times by selecting OFF (no start time).
• When operating in the Stand Alone mode, any new start times downloaded from the central will be ignored.
• When operating in the Central mode, new start times downloaded from the central will be utilized.
1. Press as needed to select the Program indicator.
2. Press to select the Start Time indicator.
3. Press or to select the desired program number (1 – 16).
4. Press – Start time 01 will begin flashing and current start time
will be shown.
5. Press or to select desired start time number (1 – 12).
6. Press – Hours digit(s) or "OFF" will begin flashing.
7. Press or to adjust hours digits up or down.
(Observe for correct a.m./p.m. time.)
Note: If no start time is desired, select "OFF" – located between
11 p.m. and 12 a.m. (23:00 and 00:00). Skip steps 8 & 9 and
continue at step 10.
Example shown: Program 1, start time 1 set to 2:30 a.m.
8. Press – Minutes digits will begin flashing.
9. Press or to adjust minutes digits up or down.
ENTER
10. Press to enter the information.
START
11. Repeat steps 5 – 10 for all desired start times for this program.
12. Press to select another program number.
13. Repeat steps 3 – 12 as required.
Program No.
6
Start Time No.
Current
Start Time
: :
: :
: : : :
: : : :
AM
AM