Set Current Time And Day; Set Station Run Times - Toro Plus Series Satellite User Manual

Set Current Time and Day

Synchronizing the controller's clock with the current time and day is an important first step in the programming
procedure. The timed events for all watering programs (when the satellite is in the Satellite Mode) are based on
the settings you will make here.
Use the following procedure to set the current time and day:
1. Press as needed to select Time/Day indicator.
2. Press – The hour digit(s) will begin flashing.
3. Press or
(Observe for correct a.m./p.m. time.)
4. Press – Minute digits will begin flashing.
5. Press or to increase or decrease minute digits.
6. Press – Day abbreviation will begin flashing.
7. Press or to select current day in either week of 14-day cycle.
ENTER
8. Press to store new information into controller memory.
START
Set Station Run Time
Note the following Station Run Time characteristics:
• Run time can be set from one minute to eight hours and 59 minutes in one-minute increments.
• Each station can have a different assigned run time within each of 16 programs.
1. Press to select the Programs indicator. The Run Time
indicator will light. The program and station number will be shown in the
left display, and the station run time will be shown in the right display.
2. Press or to select the desired program number (1–16).
Note: If the station run time has been adjusted to a value other than 100%
using the % Adjust feature, the right display will alternate between the
programmed run time and the adjusted run time. The % Adjust LED will
light momentarily when the adjusted run time is displayed.
Example Shown: Program 1, station 2, run time 1 hour and 23 minutes.
3. Press – The station number digits will begin flashing.
4. Press or to select the desired station number
Note: The controller will automatically determine the number of station
modules installed and limit the display accordingly.
5. Press to select the run time display. The hours digit will begin
flashing.
6. Press or to select the desired hours of run time (0–8).
Note: If station operation is not desired during a particular program,
enter 0:00 run time.
7. Press – The minutes digits will begin flashing.
8. Press or to select desired minutes of run time (0–59).
ENTER
9. Press to enter the information.
START
10. Repeat steps 4–8 for each station as required.
11. Press – Repeat steps 2–11 for all programs.
to increase or decrease hour digit(s).
Example: Current Time 11:28 A.M.,
Current Day Tuesday (10) Week 2.
1 2 3 4 5 6 7
Program No.
5
:
AM
:
Mo
1 2 3 4 5 6 7
Week 2
:
AM
Tu
8 9 10 11 12 13 14
Week 1 Week 2
Run Time
: :
:
Hours
Station No.
Minutes
:
: :
: :
: :
: :
: :