Related Manuals for Holy Stone HS120D
Summary of Contents for Holy Stone HS120D
- Page 1 Instructions For Use Gebrauchsanweisung V 2.0 HS120D eu@holystone.com (EU) usa@holystone.com (USA) jp@holystone.com (JP) ca@holystone.com (CA) +1(855) 888-6699 www.holystone.com...
- Page 2 English 1-35 日本語 36-60 Deutsch 61-92...
-
Page 3: Table Of Contents
Contents 1.0 Disclaimer&Warning ..................2.0 Safety Guidelines ..................... 3.0 Maintenance ..................... 4.0 Package Contents ................... 5.0 Drone’s Details ....................6.0 Transmitter Details ..................7.0 Joystick Mode ....................8.0 Installation 8.1 Propellers ....................8.2 Landing Gear ..................... 8.3 Camera ......................9.0 Charging ......................10.0 Using the Application 10.1 Download APP .................. -
Page 4: Disclaimer&Warning
. You agree to use this product only for purposes that are proper and in accordance with local regulations, terms and all applicable polices and guidelines Holy Stone may make available. - Page 5 ④ Please do a thorough check of the product before each use. Inspect the integri- ty of the parts, any signs of cracks and wear of the propeller, battery power and effectiveness of the indicator, etc. If after doing a complete check any issues are found, please refrain from using the product until the issue has been resolved.
- Page 6 2.3 Operation Requirements： ① Please don’t use this product to follow any moving vehicles . ② During the flight, only turn off the motor in case of an emergency. ③ Please flight the drone back to you as soon as possible when the battery is running low.
- Page 7 ⑦ It is recommended to only use the USB charging cable that comes with the drone to charge the battery. ⑧ Don't connect the battery directly to wall outlets or car cigarette -lighter sockets. ⑨ Don't attempt to disassemble or modify the battery in any way. ⑩...
-
Page 8: Maintenance
3.0 MAINTENANCE ① Clean the product after each use with a clean, soft cloth. ② Avoid prolonged exposure to direct sunlight and avoid buildup of heat on the drone. ③ This device is not waterproof and must not be submerged in water under any circumstance. -
Page 9: Package Contents
Screws Propeller Gear ×4 ×2 ×1 ×1 Caps Landing Gear Wrench Screwdriver Instructions For Use Gebrauchsanweisung V 2.0 HS120D usa@holystone.com (USA) eu@holystone.com (EU) ca@holystone.com (CA) jp@holystone.com (JP) +1(855) 888-6699 www.holystone.com ×1 ×1 ×1 Battery 8GB TF Card Instructions Charger Hub... -
Page 10: Drone's Details
5.0 DRONE’S DETAILS Propeller B Propeller A Landing Gear Propeller A Propeller B HD Camera Indicator Light Power Switch... -
Page 11: Transmitter Details
6.0 TRANSMITTER DETAILS Antenna Phone Holder Power Indicator One Key Take-off/ Headless Mode/ Landing GPS Mode Left Joystick Right Joystick Return to Home Power Switch Foldable Handle One Key Return Headless Mode Indicator Light Indicator Light Speed Switch Photo/Video Indicator Light Indicator Light Camera Angle Adjustment... -
Page 12: Joystick Mode
7.0 JOYSTICK MODE 7.1 MODE 2 (Left hand throttle MODE 2 will be default setting.) Left Joystick Right Joystick Forward Ascend Down Descend Down Backward Left Left Right Right Turn Left Turn Right Fly to Left Fly to Right - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 7.2 MODE 1 To enter MODE 1, turn on the transmittter while holding the “... -
Page 13: Installation
8.0 INSTALLATION 8.1 Propellers Spacer Ring Propeller Please note that the letter “A ” “ B ” is printed on each propeller. Make sure all the propellers are attached in the correct motor position. Install the propeller, spacer ring, propeller cap and screw to the motor shaft to fix. -
Page 14: Landing Gear
8.2 Landing Gear Pic.1 Removal : Use the wrench to press the fixed buckle, and then push out the landing gear to remove. (Pic.1) Pic.3 Pic.2 Installation: Align the landing gear with the buckle (Pic.2), and push the landing gear inward (Pic.3) to complete the installation. -11-... -
Page 15: Camera
8.3 Camera Pic.4 Pic.5 Pic.6 1) Plug the camera wires as pictured into the connection ports on the bottom of the drone: >>> Smaller wire should be connected to smaller ports while the Bigger wire connects to bigger port. (Pic.4) >>>... -
Page 16: Charging
9.0 CHARGING 9.1 Drone Battery Press the buckle and Phone adapter: Charging time: 120 minutes pull out the battery 1A/ 2A (Depending on charging power) ---- from the drone. (Not included) (Charging) (Fully Charged) Connect the battery charger hub with the battery, then, connect the USB charging cable of the charger hub to a computer or a USB adapter. -
Page 17: Using The Application
10.0 USING THE APPLICATION 10.1 Download APP Android APP on Google play Scan the QR code, connect to the App Store™ or Google™ Play and download the “ HS GPS V1” application for free. 10.2 Using the Application ① As shown above, pull up the phone holder and lock the phone. ②... -
Page 18: Operation Guide
11.0 OPERATION GUIDE All of the following operations on this manual under MODE 2. 11.1 Pairing TAIL ① Insert the side of the battery print- ed with the letter “UP” upward into the drone, and then long press the Power Switch to turn on the drone. HEAD ②... -
Page 19: Calibrating The Compass
11.2 Calibrating the Compass Step 1: Simultaneously push the left stick to top right corner and the right stick to the top left corner. The front Pink lights and the rear Purple light will flash quickly. Step 2: until Hold the drone and rotate it horizontally the rear lights turn solid Purple. -
Page 20: Calibrating The Gyro
Step 3: Hold the drone and rotate it vertically until the front Pink lights and the rear Purple light turn solid. 11.3 Calibrating the Gyro Simultaneously push the left stick to top left corner and the right stick to the top right corner. -
Page 21: Gps Searching
11.4 GPS Searching ( DO NOT use GPS Mode indoors ) — Place the drone on a flat and dry surface where is unobstructed and lit . — LED Flight Indicators will turn to blink Blue (Back) and White (Front) . This means the drone is searching the GPS Signal. -
Page 22: Unlock The Motor
11.5 Unlock the Motor Simultaneously push the left stick to lower right corner and the right stick to the lower left corner. The propellers rotate, indicating that the drone is unlocked. 11.6 One Key Takeoff/ Landing ① ② Landing Take-off ①... -
Page 23: Functions Details
12.0 FUNCTIONS DETAILS 12.1 APP Functions Waiting for GPS Signal D:00 H: 0.0 DS: 0.0 VS: 0.0 Return: Returns the main interface. Controls ON/OFF TapFly: Operator can set any points on the map to draw the flight path, and then the drone will fly along this route. (It is recommended to enlarge the map.) Media Gallery:... - Page 24 Follow Me: There are two modes of Follow Me Mode and Lock Follow Mode. Follow Me Mode: The drone stays at a distance from the operator and following the GPS position of the phone. Locked Follow Mode: After locking the following target, the camera is always oriented towards the following target, but the position of the drone remains unchanged.
-
Page 25: Beginner's Mode
12.2 Beginner’s Mode The Default GPS Mode is Beginner Mode, Under Beginner Mode: 1. Flight Distance is limited between 0~30m / 0~98.4feet. 2. Flight Altitude is limited between 0~30m / 0~98.4feet. 3. RTH Altitude is under 25m / 82feet. You only can Turn-off the BEGINNER MODE to modify the parameters in the APP on your phone after you complete the Compass Calibration operations. -
Page 26: Speed Switch
12.4 Speed Switch Decelerate Accelerate This drone comes with 3 speed modes (Low/ Medium/ High). Dial the wheel ( ) to the right to accelerate. Dial to the left to decelerate. SPEED If the Speed Indicator Light on the transmitter is turned off, it means the drone is in low speed. -
Page 27: Trimmer Function
12.6 Trimmer Function (Trim under NO GPS Mode) F/B Sideways Drift Trim : If the drone drifts forward, hold down the Trim- mer button ( ) and do not release it while pushing the direction joystick down to balance the drone; If the drone drifts backwards, hold down the Trimmer button and do not release it while pushing the direction joystick up to balance the drone. -
Page 28: Headless Mode
12.7 Headless Mode 1. Press the Headless Mode button ( ) on the transmitter. A beep will be heard from the transmitter, and the Headless Mode Indicator on the transmitter lights up, indicating that the drone enters Headless Mode. 2. Press the Headless Mode button ( ) again, and you will hear one long beep, the Headless Mode Indicator on the transmitter is off which indicates the drone exits the Headless Mode. -
Page 29: Return To Home
12.8 Return to Home (RTH) The Return to Home (RTH) function brings the drone back to the last recorded Take-Off Point. This function can only be achieved in GPS mode. There are three types of RTH: Smart RTH / Low--Battery RTH / Failsafe RTH. 12.8.1 Smart Return To Home Press the Return to Home button ( ) on your transmitter, and the... -
Page 30: Specifications
13.0 SPECIFICATIONS DRONE Model: HS120D Weight: 219g/ 7.7oz Flight Time: 16 minutes Motor Model: 1020 Operating Temperature Range: 32° to 104°F Dimensions: 270 x 270 x 120mm TRANSMITTER Operating Frequency: 2.4GHz MAX Transmission Distance: 984 feet (outdoors and unobstructed) Battery Type: 3.7V 300mAh Li-Po battery Charging Time: 60min Operating Temperature Range: 32°... - Page 31 CAMERA Video/ Photo Resolution: HD1920×1080p (stored in TF card) HD1280×720p (stored on mobile phone) Lens：FOV 120°/2.0 FPV Distance: 328~492 feet (outdoor and unobstructed) Controllable Range: Pitch: -75° to 0° Photo: JPEG Video: AVI Max Video Bitrate: 25 fps MAX Supported TF Cards: 32 GB (Not included) Operating Temperature Range: 32°...
-
Page 32: Trouble Shooting
14.0 TROUBLE SHOOTING Problems Reasons Solutions Drone flashes and don't 1. Transmitter is not synced 1. Refer to the Manual respond to the transmitter to the drone. and re-sync the drone. during operation. 2. Insufficient battery power. 2. Recharge the battery. 1. -
Page 33: General Information
16.0 GENERAL INFORMATION FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interfer- ence that may cause undesired operation. - Page 34 WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF Exposure The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with minimum distance 20cm between the radiator &...
- Page 35 CAN NMB-3 (B) RF Exposure Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonne- ments IC établies pour un environnement non contrôlé.
- Page 36 BATTERY WARNING: 1. Failure to follow all the instructions may result in serious injury, irrepara- ble damage to the battery and may cause a fire, smoke or explosion. 2. Always check the battery’s condition before charging or using it. 3. Replace the battery if it has been dropped, or in case of odor, overheat- ing, discolouration, deformation or leakage.
- Page 37 We, Xiamen Huoshiquan Import & Export CO., LTD hereby, declare that the essential requirements compliance with the Directive 2014/53/EU, the RoHS Directive 2011/65/EU and Safety Directive 2009/48/EC have been fully fulfilled on our product with indication below: REMOTE CONTROL MODEL/RADIO CONTROLLED Product Name: Model/Mark : HS120D/HOLYSTONE -34-...
- Page 38 The Statement of compliance is available at the following address: http://www.holystone.com/docs/HS120D_EU_DOC.pdf This product can be used across EU member states. MANUFACTURER INFORMATION Manufactured by Xiamen Huoshiquan Import & Export CO., LTD Room 703,No. 813-2 Xiahe Road, Siming District, XIAMEN, China +1(855) 888-6699 -35-...
Need help?
Do you have a question about the HS120D and is the answer not in the manual?
Questions and answers