Kwikset Aura Installation And User Manual

67375-002
Rev 02
Installation and User Guide
Required tools
Ruler Phillips head screwdriver
Additional Tools (depending on application)
Hammer Wood block Chisel
1 Prepare the door and check dimensions
A
Make sure your door is compatible. If you have a standard deadbolt mounted
separately from the handle below it, your door is compatible.
Compatible
C Measure to confirm that the hole in the door is either
2-1/8" (54 mm) or 1-1/2" (38 mm).
2-1/8"
54 mm
or
1-1/2"
38 mm
2
Install the latch and strike
A
Is the door edge chiseled?
YES
or
chiseled
Use latch "A". If the
latch bolt is not already
extended, extend the
latch bolt as shown.
A
Kwikset
1-800-327-5625
www.kwikset.com
Not Compatible Not Compatible
Rim Mortise
Lock Lock
D Measure to confirm that the backset is
either 2-3/8" or 2-3/4" (60 or 70 mm).
Note: Additional door
preparation may be
required for doors with
1-1/2" (38 mm) holes.
Consult the deadbolt
drilling instructions at
kwikset.com/doorprep
2-3/8" or 2-3/4"
60 or 70 mm
(2x)
For
Latch / Strike
Bag
03809
B
Hold the latch in front of the door hole, with the latch
face flush against the door edge.
NO
not
chiseled
Use latch "B" (not
included). If the latch
bolt is not already
extended, extend the
latch bolt as shown.
C
Is the D-shaped hole centered in the door hole?
B
D-shaped hole
No adjustment is required.
Proceed to next step.
Parts List
Mounting Adapter
Plate Ring
Keys
Batteries
Latch A
Latch B
"B" is not included.
If needed, please contact
Kwikset to order a drive-in
latch for your lock.
Not Compatible
Integrated
Interior
E Measure to confirm that the hole
in the door edge is 1" (25 mm).
b a
c k
s e
t
(2x)
46780
actual size
A
B
YES NO
or
D-shaped hole
Rotate latch face as
shown to extend latch.
A
B
1 / 4
Exterior Assembly Interior Assembly
For Latch / Strike For Lock
Strike 03809
SmartKey
49191
46780
If drilling a new door, use the supplied template and the complete
door drilling instructions available at kwikset.com/doorprep
B
Remove your existing deadbolt
from your door.
F Measure to confirm that the door is between
1-3/8" and 2" (35 mm and 51 mm) thick.
1"
25 mm
(2x) (2x)
D
Which latch are you installing?
Latch "A"
or
UP is
on top.
or
A
or
03809*
(2x)
*Use longer
screws if
holes are
worn out.
E
Install the strike on the door frame.
Make sure the hole in the door frame is drilled a
minimum of 1" (25 mm) deep.
Longer screws
install closest to
the door jamb.
46780
(4x)
48654
Tool
64109 68611
1-3/8" –2"
35 – 51 mm
actual size
Latch "B"
B
UP is
on top.
wood
block
door frame