Installing The Auxiliary Handle - Toro 51480A Operator's Manual

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
1
Installing the Auxiliary
Handle
Parts needed for this procedure:
1 Auxiliary handle
1 Latch
1 Brace
1. Position the auxiliary handle on the shaft of the trimmer with
the smooth surface facing you
1. Auxiliary handle
2. Latch
Description
Auxiliary handle
Latch
Brace
Guard
Phillips screw
Edge guard
No parts required
(Figure 1).
Figure 1
3. Brace
Qty.
1
1
1
1
1
1
–
2. Slide the brace into the auxiliary handle so that the brace
rests in the groove along the shaft
3. Slide the latch from the left through the handle and brace,
and tighten the latch screw with a Phillips screwdriver
(Figure 1).
g017277
4
Use
Install the auxiliary handle.
Install the guard.
Install the edge guard.
Adjust the trimmer height and the base
position.
(Figure 1).