MELICONI Control TV.1 Manual

Thank you for choosing a Meliconi remote control.
The Control TV.1 remote control is designed to command a television.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
The remote control and batteries should not be exposed to excessive heat such as sunlight, fire
or the like.
The product is not a toy. Keep out of reach of children or domestic animals.
The remote control requires 2 new 1.5V AAA/LR03 alkaline batteries, not included in the
package. Insert with the correct polarity as shown in figure.
DO NOT use rechargeable batteries.
BATTERIES TEST: Press and hold the
continuously until the button is released. If the light is off or blinks, the inserted batteries are low,
therefore they need replacement.
Do not leave exhausted batteries inserted, as liquid may leak and damage the remote control
Before using the remote control, for each device you wish to control, it is essential to set a specific code, it matched.
Identify the specific code and set it into the remote control using one of the following ways:
Use the qr-code on the side or connect to the
Once you have found the specific code for your device, set it in the remote control as described in the
ENTERING THE CODE DIRECTLY chapter.
Keep this booklet for future reference

SAFETY WARNINGS

INSERTING THE BATTERIES

5
button and check that the LED remains on

ACTIVATION OF REMOTE CONTROL

SMARTPHONE
TABLET - WEB
SMARTPHONE - TABLET - WEB
www.cme.it
Control TV.1
MANUAL
SEARCH
page and follow the instructions.