DeWalt DW625 Instruction Manual page 12

328521-01/DW624 9/6/01 8:00 AM Page 8
The direction of feed is important in router usage. Be sure the
FIG. 12
FIG. 11
cutter is rotating into the stock by moving left to right on outside
A
B
edges and clockwise on inside cuts.
Using the Parallel Guide (Fig. 15)
A parallel guide, available at extra cost, router will increase the
versatility of your router. Assemble the guide as shown in Figure
18. When it's fully assembled, insert the two bars through the
holes in the router base as shown in Figure 19. Adjust as needed D
C
for parallel routing.
The guide will adjust in all the way to the cutter. In some cases
the plastic slides on the guide will interfere with the cutter if they
FIG. 13
are not loosened and pushed back to provide clearance. Simply
loosen the two screws on each slide and adjust it accordingly.
A fine adjust feature is included on the parallel guide and is
ROUTER USING TEMPLATE
operated by rotating the fine adjust knob, shown in Figure 14.
AND GUIDE BUSHING
Turn the knob clockwise to move the guide in (closer to the bit).
Turn the knob counterclockwise to move the guide out (away from
the bit).
FIG. 14
FIG.10
FIG. 15
SHORTEST SCREW
TURRET STOP
FINE ADJUST KNOB
8