Viewing Converter Status; Editing Parameters - Siemens SINAMICS V20 Operating Instructions Manual

5.1.3

Viewing converter status

The display menu provides a basic monitoring view of some key parameters such as
frequency, voltage, current, and so on.
Note
• If you have set P0005 to a non-zero value which represents the parameter number
selected in P0005, then the converter displays the value of the selected parameter in the
display menu by default. For more information about normal editing of parameters, see
Section "Editing parameters (Page 57)".
• For more information about the display menu structure with active faults, see Section
"Faults (Page 333)".
5.1.4

Editing parameters

This section describes how to edit the parameters.
Parameter types
Parameter type
CDS-dependent parameters
DDS-dependent parameters
Other param-
eters
* Each CDS-dependent parameter has only one default value, despite of their three indices.
SINAMICS V20 Converter
Operating Instructions, 10/2019, A5E34559884-012
Multi-indexed parameters
Index-free parameters
Exception: By default, P1076[0] and P1076[2] are set to 1 while P1076[1] is set to 0.
Commissioning via the built-in BOP
5.1 The built-in Basic Operator Panel (BOP)
Description
Dependent on Command Data Set (CDS)
•
Always indexed with [0...2] *
•
Available for CDS switching via P0810 and P0811
•
Dependent on Drive Data Set (DDS)
•
Always indexed with [0...2]
•
Available for DDS switching via P0820 and P0821
•
These parameters are indexed with the range of indices
dependent on the individual parameter.
These parameters are not indexed.
57