Clicgear 3.0 Replacement Manual page 3

12
The Brake Washer will be placed between the metal
end cap of New Brake Cable Sheath and the New
Umbrella Brake Mount.
14
CROSS
SCREW
DRIVER
Reinstall the two screws that hold the Umbrella Brake
Mount to the bottom of the tray.
16
Tighten the cable lock nut while holding the brake
hammer in the approximate position shown.
BRAKE CABLE
REPLACEMENT
13
Assemble the Brake Lever on New Umbrella Brake
Mount, push the end of the New Brake Cable Sheath
and Brake Washer into it.
15
Push the cable bolt with one (1) washer into the brake
hammer with the washer between the cable and
plastic. Then install the second washer and lock nut
on the opposite side of the brake hammer.
17
10MM
SOCKET
DRIVER
Adjust the brake cable until the brake hammer fully
engages the brake gear, as shown, when the brake is
in the ON position.
PAGE: 3 OF 3
BULLETIN
04
MODEL
3 0
.
CROSS
SCREW
DRIVER