Advertisement
Quick Links
SB
Service Bulletin SB-02 covers the replacement of
broken brake handles on the Clicgear Cart, Model 1.0
and Model 2.0
2
Remove the two washers and lock nut from the cable
nut assembly.
Leave the cable nut and protective
cable end cap attached to the brake cable as shown.
4
Using needle nose or similar pliers, remove the
remaining portion of the Brake Handle from the Brake
Cylinder.
BRAKE HANDLE
REPLACEMENT
1
Remove the 10mm Nut from the Cable Nut Assembly.
This should loosen the cable and the Brake Hammer
should swing upwards when free.
3
Unscrew the two screws that secure the Brake
Cylinder to the under side of the tray.
5
Pull the cable barrel end up and out of the brake
handle.
PAGE: 1 OF 2
BULLETIN
MODEL
02
1
CROSS
SCREW
DRIVER
MODEL
2
0
0
.
.
10MM
SOCKET
DRIVER
Advertisement
Related Manuals for Clicgear 1.0
Summary of Contents for Clicgear 1.0
- Page 1 DRIVER Service Bulletin SB-02 covers the replacement of Remove the 10mm Nut from the Cable Nut Assembly. broken brake handles on the Clicgear Cart, Model 1.0 This should loosen the cable and the Brake Hammer and Model 2.0 should swing upwards when free.
- Page 2 BULLETIN MODEL MODEL BRAKE HANDLE REPLACEMENT CROSS SCREW DRIVER Install the new Brake Handle onto the cable. Carefully Insert the new brake handle into the brake cylinder. seat the cable end barrel into the handle using a small Push any excess cable back inside the cable housing. cross screw driver.
Need help?
Do you have a question about the 1.0 and is the answer not in the manual?
Questions and answers