Spindle Position/Speed Control Switch M14, M15 - GSK 980TDi User Manual

2.1.13 Spindle Position/Speed Control Switch M14, M15

Command format：M14；
M15；
Command function：M14：Spindle is in the position control mode from speed control mode;
Note: Refer to time sequence and logic of M14, M15 defined by standard PLC ladder in
INSTALLATION & CONNECTION.
Ⅲ
2.1.14 Spindle Clamped/Released M20, M21
Command format：M20；
M21；
Command function：M20：Spindle clamped
Note: Refer to time sequence and logic of M20, M21 defined by standard PLC ladder in
Ⅲ INSTALLATION & CONNECTION.
nd
2.1.15 The 2 Spindle Position/Speed Switch M24, M25
Command format：M24；
M25；
Command function： M24： The 2
Note: Refer to time sequence and logic of M24, M25 defined by standard PLC ladder in
Ⅲ INSTALLATION & CONNECTION.
2.1.16 Lubricating Control M32, M33
Command format：M32；
M33；
Command function：M32：Lubricating ON;
Note: Refer to time sequence and logic of M32, M33 defined by standard PLC ladder in
Ⅲ INSTALLATION & CONNECTION.
2.1.17 Spindle Automatic Gear Change M41, M42, M43, M44
Command format：M4n；(n=1, 2, 3, 4)
Command function：When the system executes M4n, the spindle changes to gear n.
Note: Refer to time sequence and logic of M41, M42, M43, M44 defined by standard PLC ladder in
INSTALLATION&CONNECTION.
Ⅲ
30
Official GSK Agents in South Africa
Tel: +27 11 626 2720, design@efamatic.com
M15：Spindle is in speed control mode from the position control mode.
M21：Spindle released
nd
spindle is switched from the speed control mode to the position
control mode;
nd
M25： The 2 spindle is switched from the position control mode to the speed
control mode.
M33：Lubricating OFF.
GSK980TDi Turning CNC System User Manual