Communications Connections; Ethernet Connection - Motorola FX7400-22350A30-US Integrator Manual

Communications Connections

Use a standard Ethernet connection or a POE Ethernet connection to connect the FX Series reader to a host or
network.

Ethernet Connection

The reader communicates with the host using an Ethernet connection (10/100Base-T Ethernet cable). This
connection allows access to the
With a wired Ethernet connection (10/100Base-T cable), power the FX Series reader using either the reader
Motorola AC power supply, or by Power-Over-Ethernet through the Ethernet cable.
Ethernet: Power through AC Outlet
The FX Series reader communicates to the host through a 10/100Base-T Ethernet cable and receives power
through a Motorola AC power supply.
Route the Ethernet cable.
1.
Route the power cable.
2.
Terminate the Ethernet cable according to
3.
Connect the Ethernet cable to the LAN port on the FX Series reader. See
4.
Connect the other end of the Ethernet cable to the host system LAN port.
5.
Connect the Motorola AC power supply to a wall outlet.
6.
Insert the power supply barrel connector into the FX Series reader power port. See
7.
Verify that the unit booted properly and is operational.
8.
On a networked computer, open an internet browser and connect to the reader. See
9.
page 4-3.
Log in to the
10. Administrator Console
Ethernet: Power through POE
The POE installation option allows the FX Series reader to communicate and receive power on the same
10/100Base-T Ethernet cable.
Insert the POE Ethernet connector on the RJ45 Ethernet cable into the reader 10/100BaseT Ethernet port. See
1.
Figure 2-4 on page
Connect the other end of the cable to an Ethernet network with POE capability.
2.
Verify that the reader booted properly and is operational.
3.
3-7.
On a networked computer, open an internet browser and connect to the reader. See
4.
page 4-3.
Log in to the
5. Administrator Console
CAUTION
Administrator Console
. See
2-5.
. See
Do not connect to PoE networks outside the building.
, used to change reader settings and control the reader.
Table A-2 on page A-4.
SeeSystem Start-up/Boot LED Sequence on page
Administrator Console Login on page
SeeSystem Start-up/Boot LED Sequence on page
Administrator Console Login on page
Installation and Communication
Figure 2-4 on page 2-5.
Figure 2-4 on page
Connect to the Reader on
4-8.
Connect to the Reader on
4-8.
3 - 5
2-5.
3-7.