Required Tools And Materials; Decomissioning And Disposal; Cabling Recommendations - Siemens RUGGEDCOM RX1512 Installation Manual

RUGGEDCOM RX1512
Installation Guide
Section 1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RX1512:
AC/DC power cord (16 AWG)
Lightning protector
Shielded coaxial cables
SIM Card(s) provided by the network carrier
Flathead screwdriver
Phillips screwdriver
4 x #6-32 screws
Braided or equivalent ground wire
Section 1.4

Decomissioning and Disposal

Proper decomissioning and disposal of this device is important to prevent malicious users from obtaining
proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of service, either permanently or
for maintenance by a third-party, make sure it has been fully decommissioned.
For more information, refer to the associated User Guide.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related accessories, contact a facility
certified to dispose of waste electrical and electronic equipment. Recycling and disposal must be done in
accordance with local regulations.
Section 1.5

Cabling Recommendations

Siemens recommends using SIMATIC NET industrial Ethernet shielded cables for all Ethernet ports.
CONTENTS
• Section 1.5.1, "Protection On Twisted-Pair Data Ports"
Required Tools and Materials
Tools/Materials
For connecting power to the device.
For protecting the device from harmful electrical strikes.
For connecting the device to antennas and an Ethernet network.
For accessing a network carrier's cellular network. Required only if a
cellular modem module is equipped.
For mounting the device to a DIN rail.
For mounting the device to a panel.
For mounting the device to a panel.
For grounding the device to safety Earth.
Introduction
Purpose
Chapter 1
3