Replacing The Device; Transportation And Storage; Return Procedure - Siemens SITRANS F Series Compact Operating Instructions

6.4

Replacing the device

Corrosive substances
Risk of chemical burns when replacing the sensor.
The sensor in the device contains corrosive substances that result in burns on unprotected
skin.
● Make sure that the sensor enclosure is not damaged when replacing the sensor.
● If contact with the corrosive substances occurs, rinse the affected skin immediately with
6.5

Transportation and storage

To guarantee sufficient protection during transport and storage, observe the following:
● Keep the original packaging for subsequent transportation.
● Devices/replacement parts should be returned in their original packaging.
● If the original packaging is no longer available, ensure that all shipments are properly
packaged to provide sufficient protection during transport. Siemens cannot assume liability
for any costs associated with transportation damages.
Special conditions for storage and transportation of the device are listed in Technical data
(Page 57).
6.6

Return procedure

Enclose the bill of lading, return document and decontamination certificate in a clear plastic
pouch and attach it firmly to the outside of the packaging.
SITRANS FC430
Compact Operating Instructions, 09/2019, A5E39940293-AB
CAUTION
large amount of water to dilute substance.
NOTICE
Insufficient protection during storage
The packaging only provides limited protection against moisture and infiltration.
● Provide additional packaging as necessary.
Service and maintenance
6.6 Return procedure
55