There are no switches on an expansion unit. Power is turned on and off with
a control signal that is routed from the base unit via the ENC cables that are
connected to the ENC unit in the expansion unit.
Figure 1-12: Front View of an Expansion Unit
Figure 1-13
shows the front of an expansion unit (factory designation
RKAK) with the decorative bezel removed and the disk drives in the front
of the array exposed.
Figure 1-13: Expansion Unit Front View, Bezel Removed
Table 1-8: Expansion Unit Front View, Bezel Removed
Item
Description
Disk Drives, showing
1
the status LEDs
Hitachi AMS 2000 Family Storage System Service Guide
Item
Description
2
Locate LED
Introduction
Item
Description
3
Power LED
1–15