Product Information; Misuse; Scope Of Delivery; Declaration Of Conformity - Bosch Worcester 2000 Series Installation And Maintenance Instructions Manual

3

Product Information

Appliance features
• Aluminium-silicon heat exchanger, which has an extra-large surface
area for enhanced heat exchanger efficiency.
• NOx emissions 39mg/kWh.
• Direct burner ignition.
• Zero pressure governor gas valve with fully modulating fan.
• Display for appliance status and access to diagnostics, system and
commissioning parameters.
• 1 hour memory retention after power interruption.
• Low electrical power consumption during operation and stand-by
modes.
• Modulating pump.
• Condensing in CH and DHW modes.
• Two star Hot Water Comfort measured to EN13203 Part 1 in comfort
mode with DHW pre-heat ON.
• Eco mode, to use gas on demand.
• Plate type DHW heat exchanger.
• Galvanised steel wall mounting bracket.
• Only Worcester controls, see accessories list for available controls.
– Worcester Comfort+ II RF control included with every 2000
boiler.
• Condensfit II flue systems 60/100 and 80/125 mm allows plume re-
direction.
• Condensfit II flue systems 60/100 allows the ability to attach plume
management kit.
• Front accessible components for maintenance.
3.1

Misuse

Appliance must be used as per the intended use statement. Operation
outside the parameters of the intended use is considered misuse and
could cause harm to people and damage to property.
Accessories should be as per accessories list. Minimum operational
parameters are included in this document.
Using the appliance outside of its intended use may also invalidate the
manufacturer's guarantee.
Worcester 2000 – 6 721 814 551 (2019/09)
3.2

Scope of delivery

Fig. 1
[1] Wall mounted gas-fired condensing combi appliance.
[2] Wall mounting bracket.
[3] Fittings pack.
[4] Condensate hose connector.
[5] Valves set.
[6] Compression fitting adapters set.
[7] Literature pack:
– Installation and Maintenance Instructions,
– User Instructions,
– Wall mounting template.
[8] Guarantee card
[9] ErP labels and system fiche.
[10] Comfort+ II RF controller and Key
3.3

Declaration of Conformity

The design and operation of this product comply with European
Directives and the supplementary national requirements. Conformity
has been demonstrated by the CE marking.
You can ask for a copy of the declaration of conformity for this product.
For this see the contact address on the back cover of these instructions.
3.4

Appliance type overview

This appliance are for use with:
• Natural Gas (Cat.II 2H type C13, C33 & C53)
This document refers to the following appliance types:
Appliance type
GC2000iW 25 C NG 7 736 902 027
GC2000iW 30 C NG 7 736 902 028
Table 2 Type overview
The name of the appliance consists of the following parts:
• GC2000iW: Type name
• 25 or 30: Hot water output in kW
• C: Combi appliance
• NG: Gas type (Natural Gas)
Product Information
Part number Gas Council number
47-800-25
47-800-24
1
2
3
4
5
6
7
8
9
10
7