Advertisement
9. Mount the lower seat brackets to the seat base with the
(4) bolts, spacers and nuts previously removed (Figure
2).
10. Position the seat assembly onto the seat suspension.
Make sure a washer is on each adjuster stud before
placing it on the suspension (Figure 2).
11. Secure the seat adjusters and the manual tube clamps
to the seat suspension with the (4) nuts previously
removed (Figure 2).
12. Reinstall the control arm with the (2) control arm
adjusting bolts previously removed (Figure 1). Adjust
as desired.
13. Plug the seat switch connector into the wire harness at
the rear of the control arm.
14. Locate the air ride seat suspension plug on the wire
harness at the rear of the control arm. Remove the
plug from the connector on the harness. Plug the seat
suspension connector into the wire harness connector.
15. Remove the access panel from the side of the control
arm (Figure 1).
Note: View the decal on the back side of the access
cover for the optional air ride seat suspension fuse
location. If there is an open slot in the fuse block for
the suspension, insert a 20 amp and proceed to step 20.
1. Fuse block
16. Mount the fuse block next to the existing fuse block
with (2) #8 x 1/2 inch screws (Figure 3).
17. Connect the large red wire from the traction unit wire
harness to the wire on the fuse block.
18. Connect the red wire with the white stripe labeled "Air
Ride Seat" to one of the red wires from the fuse block.
19. Insert the 20 amp. fuse into the fuse slot where the
wire is connected.
Figure 3
2. Fuse 20 amp
20. Install the access panel to the control arm (Figure 1).
21. Plug the traction unit power harness, from back of
control arm into the seat harness connector.
22. Slide the seat completely forward and backward to
ensure proper operation and that the seat wires and
connectors are not pinched or do no contact any
moving parts.
23. Connect the negative battery cable to the battery.
Operation
Seat Adjusting Knobs
Adjusting Lever
Fore and aft seat adjustment (Figure 4).
Air Control Valve
Push in control valve to inflate suspension. Pull out valve to
deflate suspension (Figure 4).
Weight Guide
Indicates when seat is adjusted to the weight of the operator
(Figure 4).
1. Weight guide
2. Air control valve
2
Figure 4
3. Adjusting lever (fore and
aft)
Advertisement
