Husqvarna Automower 105 Operator's Manual page 34

Message Cause
Temporary battery
Temporary battery or firmware related
problem
issue in the product.
Battery problem
Charging current
Wrong or faulty power supply unit.
too high
Message Cause
No loop signal
The power supply is not connected.
The low voltage cable is damaged or
not connected.
The boundary wire is not connected to
the charging station.
Boundary wire broken.
ECO mode is activated and the product
has attempted to start outside the
charging station.
The boundary wire is crossed on its
way to and from an island.
The connection between the product
and the charging station has been bro-
ken.
Disturbances from metal objects (fen-
ces, reinforcement steel) or buried ca-
bles close by.
34 - Troubleshooting
Action
Restart the product.
Disconnect and reconnect the battery.
If the problem remains, the message
requires action by authorized service
technician.
Restart the product.
If the problem remains, the message
requires action by authorized service
technician.
Action
Check the wall socket connection and
whether an earth-fault breaker has trip-
ped or not.
Check that the low voltage cable is not
damaged. Check that it is also properly
connected to the charging station and
to the power supply.
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Replace connectors if dam-
To install the boundary
aged. Refer to
wire on page 18 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
Find breaks in the
nal coupler. Refer to
loop wire on page 38 .
Place the product in the charging sta-
tion and press the STOP button. Refer
ECO mode on page 23 .
to
Check that the boundary wire is laid ac-
cording to instructions, e.g. in the right
direction around the island. Refer to
install the boundary wire on page 18 .
Place the product in the charging sta-
tion and generate a new loop signal.
Try moving the boundary wire.
1285 - 002 - 20.08.2019
To