Husqvarna Automower 105 Operator's Manual page 21

Model Approximate operation ca-
pacity, m
®
Automower 105 43 / 50
Example: A lawn of 500 m
®
Automower 105.
2
500 m / 43 ≈ 12 h.
2
600 yd / 50 ≈ 12 h.
Days / h / day
week
7 12
3.9.2.2 To set the timer
To get access to the menu
1. Do steps 1–3 in
on page 20 .
2. Use the multi-choice buttons to move
through the menu structure to select
3. Use the multi-choice buttons to select
hours 1 or Work hours 2 .
4. Enter the time with the number buttons.
OK .
5. Push
6. Use the multi-choice buttons to select
days .
7. Use the multi-choice buttons to select the
days that the product will operate.
OK .
8. Push
3.9.2.3 To reset the timer setting
You can remove all timer settings and use the
factory setting. The factory timer setting lets the
product operate all hours each day of the week.
Timer and Standby on page 26 .
Refer to
To get access to the menu
1. Do steps 1–3 in
on page 20 .
2. Use the multi-choice buttons to move
through the menu structure
timer .
OK .
3. Push
3.9.3 Installation
In the Installation menu it is possible to
adapt the settings of the product for
best mowing result.
3.9.3.1 Guide width
1285 - 002 - 20.08.2019
2 2
/h / yd /h
2 2
/ 600 yd , cut with an
Timer settings
07:00-19:00 / 7:00
am-7:00 pm
Timer .
Work
Work
Timer > Reset
The guide width is a measure of how far from the
guide wire the product is allowed to travel when it
follows this to and from the charging station. The
area beside the wire which the product uses is
called the Corridor.
The product has a default setting for
wide corridors. To further reduce the risk of
tracks forming, it is recommended to select as
wide corridor as possible. The
setting is not normally recommended, but in a
garden with one or many narrow passages, a
narrow corridor may be the only option. The
Narrow corridor setting increases the risk for
tracks forming along the guide.
3.9.3.2 Remote start 1
Remote start function is used to guide the
The
product to remote parts of the work area. If the
work area includes areas that are connected with
Remote start function is
narrow passages, the
useful to be able to maintain a well-cut lawn in all
parts of the yard. The product begins to mow
Remote start point. At all
when it reaches the
other times, the product leaves the charging
station in the standard manner and starts to mow.
To set the Remote start function
1. Do steps 1–3 in To get access to the menu
on page 20 .
2. Use the multi-choice buttons to move
through the menu structure to select
Installation > Remote start > Proportion .
3. Select how often the
shall be used. There are 5 options:
• Never (0%)
Medium
Narrow corridor
Remote start function
Installation - 21