B.E.G. Luxomat PD2N-M-1C-LED Operation Manual

PD2N-M-1C-LED
Operation manual
Content
1. Basics
1.1 General
1.2 Mounting location
1.3 Switching detectors
2. General device information
2.1 Basic characteristics
2.2 Set-up of device (by remote control)
2.3 Device PIN
3. Self-test cycle
4. Operating modes
4.1 Full automatic (FULL)
4.2 Full automatic with corridor function
(FULL+CORRIDOR)
4.3 Semi-automatic (HALF)
4.4 Master-Slave mode
5. Daylight-dependent switch-off
6. External push button functions
7. Brief description of functions
8. Factory settings / set-up options
9. Commands and parameters
9.1 Parameter
9.2 Commands

1. Basics

1.1 General

Passive infrared occupancy detectors register heat movements and
convert them to signals that can be analysed by a processor.
The occupancy detector's general functionality is described in the
instructions which come with the device.
Additional basic functions regarding motion detection and switching
of the lighting are outlined below.
1

1.2 Mounting location

1
The most important factor in motion detection is the right choice of
1
mounting location.
1
The occupancy detector should be mounted so that the main direction
1
of motion is always tangential (side-to-side across the device).
1
2
The master device must always be installed at the location with least
2
daylight.
2
The following sources of interference can lead to unwanted triggering,
since they can also produce differences in temperature:
2
2
1. radiant heaters
2. ventilation systems which emit hot or cold air
2
3. lights directly in the detection area
3
Accordingly, the detector must be positioned far from these sources.
3
If even the smallest movements are to be recognised (e.g. working at
3
a computer keyboard), we recommend that you choose a mounting
3
location directly above the desk. This will ensure that detection takes
place.
4
Please always follow the mounting height given for the devices.
4
Smaller mounting heights reduce the range. Greater mounting heights
4
increase the range but also reduce sensitivity.
4
5
1.3 Switching detector
The PD2N-M-1C-LED is a switching detector. The brightness level from
which the lighting is switched on is freely selectable. In switching
mode, this value is known as a switch-on threshold. If the brightness
level measured by the detector is below the switch-on threshold set,
any movement in the room will cause the lighting to switch on.

2. General device information

2.1 Basic characteristics

94055 - PD2N-M-1C-LED-FC
The device is a bidirectional remote control-capable occupancy
detector for interior applications with circular detection area and
integrated LED light.
After switching off the main lighting, an orientation or night light can
be activated with its integrated LED light. An individual brightness
and follow-up time can be selected for both orientation and night
light.
1