Table of Contents
Advertisement
Installation dimensions of
locking bolt
Anti-tip device, front view
Model
HR 1936-1
915 mm
HR 1956-1
1220 mm
Installing the Range Cooker
with the anti-tip device
Wear safety shoes and
protective gloves.
The anti-tip device should be installed
at the back of the Range Cooker, half
way along the bottom edge.
Measure the installation space for the
Range Cooker close to floor level.
Mark the wall at the halfway point
along the niche width.
Position the notch of the anti-tip
device on the wall marking.
The anti-tip device must fit tightly
against the floor or the wall.
Width
X
97 mm
82 mm
2
1
3
Securing to the floor
2
1
3
Securing to the wall
a Anti-tip device
b Screws
c Locking nut
Secure the anti-tip device with four
screws to a surface with suitable
load bearing capacity, either to the
floor or wall.
Screw the locking nut to the bolt,
see the "Installation dimensions of
locking bolt" table.
Anti-tip device
35
Advertisement
Table of Contents
