Page 1
RETTIG (UK) Ltd., Service, Somerden Road, Hull, East Yorkshire HU9 5PE Tel 01482 713927, Fax 01482 789056, service.convectors@myson.co.uk Spare parts and technical help on all Convector products are available from Myson Service. For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk 0844 556 1818...
Page 2
Installation, Operating, Maintenance and After Sales Manual. LO-LINE RC & LO-LINE RC Heater-cooler Models: 6-4, 9-6, 14-10, 19-15 heatingthroughinnovation. Product Serial Number: Please leave this manual with the end user. Part Number: 1370057 Issue 1 For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk 0844 556 1818...
Contents General Information Heating System Design Unit Selection/Sizing Location Preparation Fixing Water Connections Electrical Connections Commissioning Procedure 10.0 Technical Data 11.0 Operating Instructions 12.0 Troubleshooting 13.0 Maintenance For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - info@mytub.co.uk 0844 556 1818...
LO-LINE RC & LO-LINE RC Heater Cooler 1.0 General Information G This MYSON LO-LINE fan convector is designed for wall G Before proceeding with the installation, the heating system mounted installation with a minimum installation height of design must be considered and the unit correctly sized to 150mm to the underside of the unit.
LO-LINE RC & LO-LINE RC Heater Cooler 5.0 Preparation Before proceeding with the installation, unpack the carton contents and check against the checklist below: 1. LO-LINE or LO-LINE Heater-Cooler unit. 2. 15mm isolating valves (1 pair). 3. Instruction manual. 4. Warranty card. 5.
LO-LINE RC & LO-LINE RC Heater Cooler 7.0 Water Connections G Connect unit to system flow and return pipes using the two LO-LINE Heater-Cooler installations with chilled water will require provision for condensate disposal in accordance with any 15mm isolating valves (see fig. 3). local regulations.
LO-LINE RC & LO-LINE RC Heater Cooler 8.0 Electrical Connection WARNING: This appliance must be earthed. The electrical installation must comply with local or national wiring regulations. G This unit is supplied with factory fitted test leads. Remove G Connect live and neutral wires to the power board terminal these and discard.
LO-LINE RC & LO-LINE RC Heater Cooler 9.0 Commissioning Procedure G Fill and vent the system. G Switch on electrical supply. G Open both valves fully and vent air from the heat exchanger G Check the operation of the unit in automatic and manual by unscrewing the air bleed valve situated above the valves in modes (LO-LINE) or heating and cooling modes (LO-LINE the angled top of the chassis.
LO-LINE RC & LO-LINE RC Heater Cooler 11.0 Operating Instructions Description In manual mode any of the three fan speeds can be selected by overriding the automatic temperature control. This means that air circulation can be provided in summer for example, or that This LO-LINE unit is fitted with a control system that provides heating performance can be controlled manually.
12.0 Troubleshooting Once installed this fan convector becomes part of a complete Note: If you call out MYSON Service to a fault detailed opposite, heating system that will generally include a boiler, pump, other or to repair a fault caused by incorrect use, a call out charge will emitters such as radiators and fan convectors, and a number of be made.
If the fan convector is still faulty after checking the above, call your installer or MYSON Service. Common Installation Faults heat, and the heating system must be correctly designed to provide adequate flow of hot water to the unit (refer to section 2).
Need help?
Do you have a question about the LO-LINE RC 6-4 and is the answer not in the manual?
Questions and answers