Myson 6-4 Installation, Operating, Maintenance And After Sales Manual

Myson 6-4 Installation, Operating, Maintenance And After Sales Manual

Lo-line rc & lo-line rc heater/cooler
Hide thumbs Also See for 6-4:

Advertisement

Installation, Operating, Maintenance
and After Sales Manual.
LO-LINE RC & LO-LINE RC Heater/Cooler
Models: 6-4, 9-6, 14-10, 19-15
heatingthroughinnovation.
Product Serial Number:
Installation Date:
Please leave this manual with the end user.
Part Number: 1371053
Issue 2
Tested to UL & CSA Standards

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6-4 and is the answer not in the manual?

Questions and answers

Summary of Contents for Myson 6-4

  • Page 1 Installation, Operating, Maintenance and After Sales Manual. LO-LINE RC & LO-LINE RC Heater/Cooler Models: 6-4, 9-6, 14-10, 19-15 heatingthroughinnovation. Product Serial Number: Installation Date: Please leave this manual with the end user. Tested to UL & CSA Standards Part Number: 1371053...
  • Page 2: Table Of Contents

    Contents General Information Heating System Design Unit Selection/Sizing Location Preparation Fixing Water Connections Electrical Connection Commissioning Procedure 10.0 Technical Data 11.0 Operating Instructions 12.0 Troubleshooting 13.0 Maintenance...
  • Page 3: General Information

    LO-LINE RC & LO-LINE RC Heater/Cooler 1.0 General Information l This MYSON LO-LINE fan convector is designed for wall l This unit is supplied with an infra red remote control system mounted installation with a minimum installation height of and has 3 operating modes: 6 inches to the underside of the unit.
  • Page 4: Preparation

    LO-LINE RC & LO-LINE RC Heater/Cooler 5.0 Preparation Before proceeding with the installation, unpack the carton contents and check against the checklist below: 1. LO-LINE or LO-LINE Heater/Cooler unit. inch isolating valves (1 pair). 3. Instruction manual. 4. Fixing kit (rubber mounts and cable gland). 5.
  • Page 5: Water Connections

    LO-LINE RC & LO-LINE RC Heater/Cooler 7.0 Water Connections l Connect unit to system flow and return pipes using the two LO-LINE Heater/Cooler installations with chilled water will require provision for condensate disposal in accordance with any inch isolating valves (see fig. 3). local regulations.
  • Page 6: Electrical Connection

    LO-LINE RC & LO-LINE RC Heater/Cooler 8.0 Electrical Connection WARNING: This appliance must be grounded. The electrical installation must comply with state or local codes. l This unit is supplied with a factory fitted 3 core cord, 6ft in length with moulded plug. Brown Blue Motor...
  • Page 7: Commissioning Procedure

    LO-LINE RC & LO-LINE RC Heater/Cooler 9.0 Commissioning Procedure l Fill and vent the system. l Refit outer cover. l Open both valves fully and vent air from the heat exchanger l Switch on electrical supply. by unscrewing the air bleed valve situated above the valves in the angled top of the chassis.
  • Page 8: Technical Data

    LO-LINE RC & LO-LINE RC Heater/Cooler 10.0 Technical Data Heating Performance Data Heat Output (Btu/h) Flowrate Model Fan Setting Entering Water Temperature (°F), entering air temperature 65°F (GPM) Boost 7997 9691 11372 13042 14702 16354 17999 19637 21269 22895 19 -15 Medium 7224 8753...
  • Page 9: Operating Instructions

    LO-LINE RC & LO-LINE RC Heater/Cooler 11.0 Operating Instructions Description that air circulation can be provided in summer for example, or that heating performance can be controlled manually. This LO-LINE unit is fitted with a control system that provides In manual mode, with water temperature control, any of the 3 either automatic or manual control of the unit.
  • Page 10: Troubleshooting

    An apparent problem with this unit may be the result of system controls being incorrectly set and can be solved easily without calling out your installer or MYSON. Before calling your installer or MYSON, please carry out the checks listed opposite.
  • Page 11: Maintenance

    If the fan convector is still faulty after checking the above, call your installer or MYSON. Common Installation Faults heat, and the heating system must be correctly designed to provide adequate flow of hot water to the unit (refer to section For optimum performance, this unit must be correctly sized to 2).
  • Page 12 MYSON Hercules Drive, Suite 4904, Colchester VT0446 802 654 7500, 802 654 7022, info@mysoninc.com, www.mysoninc.com heatingthroughinnovation.

This manual is also suitable for:

9-614-1019-15Lo-line rc

Table of Contents