Measurement Commissioning - Siemens SINUMERIK 840D sl Function Manual

2 Machine information
2.3 Test series on the machine
PROG_END:
G4 F1
M17

2.3.5 Measurement commissioning

Function description
The prolog and epilog program must be edited in order to perform measurements.
If measurements are performed on a machine for the first time, or if the prolog and
epilog program has been deleted, then a preconfigured prolog and epilog program
takes effect, which prevents the further execution of the NC programs as the NC
program code runs in an endless loop. This part of the preconfigured prolog and
epilog program must be deleted. A program code adapted to the requirements of
the machine must be used for the prolog or epilog.
Fig. 2-41: Prolog and epilog program
2-68
; is required for synchronization
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
03/2013